Help Please!!!
I am really struggling to get the angles right for an internal 90 degree corner. I have tried the angles given for the chop saw but they don’t even come close ….. I am at my wits end!!!,
Asked by: JayWil
Is it enough to use glue to fit it to the wall, or requires pins as well.
I asked at the Screwfix and they couldn’t provide this answer. The boards are heavier than a polystyrene coving, so glue on its own may not be enough, but equally, placing pins in this, may not look nice. Please advise…
I appreciate !
Asked by: ChrisManchester
I use pins in the wall till the adhesive sets. Just fill the holes after.
Answered by: AliP93
Date published: 2022-06-26
What is the weight of this pack?
We don’t have transport so would need to carry it home( shame there isn’t a delivery option!!)
Asked by: Jack184
Can you please tell me the width across for the horizontal wall measurement for this coving? I know the vertical drop down is 106mm.
I need the horizontal width for this coving please when fitted, I believe the vertical is 106mm drop down - if this can be confirmed. I am replacing old coving and need to hide the old coving marks on the walls and ceiling where I have removed it. Thanks.
Asked by: MarionSteeleCable
Hello
Thank you for your question.
The top measurement is 106mm at a 90deg angle.
Thank you for using the Screwfix Q&A service
Answered by: Jclarke71
Date published: 2022-03-02
Is the Magnusson SW63 Mitre Box big enough for this coving? And which saw would be best? Thanks
Asked by: Splankton
Hello
Thank you for your question.
You can use this mitre box for some angle but just remember a 90deg on coving is different because it is concaved and will be wrong i would invest in the correct tool for cutting coving.
we don't currently sell this item but search the below and you will find it???
Wondermitre Coving Mitre Tool £9.55
Thank you for using the Screwfix Q&A service.
Answered by: Jclarke71
Date published: 2022-02-17
