What size bolt will these take?
Once these are inserted into the wood, what size will they take?
Asked by: OooooonlyMeeee
Hello,
Thank you for your enquiry.
These will take a 6mm bolt.
Hope that helps.
Thank you for using Q&A.
MH
Answered by: Screwfix778
Date published: 2020-01-15
Is this safe to use in a high humid area?
I would like to use this in places where heat and hot water will be in contact with it. Will it rust?
Asked by: Shahidul
Hello Shahidul,
This product would not be suitable for use in areas of high humidity as it may have an accelerated rate of corrosion.
Thank you for using Q&a. (LM).
Answered by: LMac
Date published: 2017-09-20
What size drill should I use with these
I'm restoring an old park bench, the slates are made from teak, the insert nuts go into the end grain of the slates, and so far seem to be splitting the wood, rather than cutting their own thread. This was how the bench was constructed originally.
Thanks. Nick
Asked by: Drnick66
I use 7.5 mm for soft wood and 8 mm for hard wood. For faced chipboard I would suggest 7.5mm, but relieve the facing with an 8mm dril to prevent cracking.
Answered by: pkms
Date published: 2019-12-07
