Rated 5 out of
5
by
firefire from
2.5-TONNE LOW-PROFILE JACK
I needed a low profile jack to access a very low car & this one fitted the profile. Have only used it to try it out so far but performed with no problems. Followed the instructions & bled out initial air.
Straight forward to use & release the pressure to lower the arm.
Easier to use than my old one & lifts a lot higher.
Looks sturdy but a bit heavy to move around.
Date published: 2018-06-22
Rated 4 out of
5
by
DavC from
Great Jack
Great jack for the money, very solid build including metal wheels all round, far superior to some of the cheaper brands. Was purchased over other types as it has a low profile lifting arm but also will lift to 500mm ideal for work on my MR2 which is very low at the front. Its simple to position and use and has twin lifting pistons so 1 full pump lifts the car.
Date published: 2017-06-27
Is it CE marked and does it meet BS EN 1494 ?
Asked by: DIYBanburymike
Hello, thank you for the question. This item is CE approved and does conform to all required standards. Regards, Hilka Tools
Answered by: Hilka Product Expert
Date published: 2019-09-14
Will it lift with one full pump?
I just got this jack, it's great! Very pleased.
One reviewer states that one full pump will lift the car, but that's not my experience using it today. Is there a setting to make it lift in this way?
Thank you.
Asked by: HondaLass
Hello, thank you for the question and feedback. It is a great jack due to the very low / high lifting range and twin piston design. To my knowledge no jack on the market would be able to full lift a car with one pump. In my experience it takes around six pumps to get it to the full extension (which is significantly less than other jacks on the market). With regards to the reviewer depending on the type of car if the jack was at the jack point then one full pump could potentially be enough to lift a car enough to remove a wheel but this would vary car to car due to suspension set ups. There are no settings to adjust. Regards, Hilka Tools
Answered by: Hilka Product Expert
Date published: 2021-02-13
Dims
What is the dims of the product as the spec sheet dose not say how long the jack or width it is ?
Thanks
Asked by: Alljobsdone
Hello, thank you for your query. This item is 780 x 395 x 180mm. The weight of the jack is 35.2kg. Kind regards, Hilka Tools.
Answered by: Hilka Product Expert
Date published: 2019-07-30
| Specification |
| Brand |
Hilka Pro-Craft |
| Lifting Range |
75-515 mm |
| Manufacturer Guarantee |
1 Year Guarantee |
| Max Load Capacity |
2.5 Tonne |
| Pack Size |
1 |
| Pieces in Pack/Case |
1 |
| Product Type |
Low-Profile Jack |
| Total Product Weight |
33.5 kg |
Downloads
Instruction Manual
*Delivered direct from our suppliers in the number of working days stated on the delivery button
