Fixing the bottom to a batten
What is the profile of the lower part of this panel? It is completely flat allowing screwing to a batten or will this need a rebated batten for a lip to slide under?
Asked by: simbiant
Hello,
Thank you for your enquiry.
The bottom section of the panel is not flat and does have a small lip at the bottom, (so in answer to your question a small rebate is necessary).
Thank you for using Q&A.
Answered by: Screwfix778
Date published: 2022-06-15
Grove Front & End Bath Panels
Hi will the Grove front and end panels slot into each other, with the left hand side of the end panel slotting into the right hand side of the front panel.
Asked by: DavidD55
how does it fit to the front panel?
hi, how on earth does the end panel fit into the front long panel neatly? the end of the front panel has a corner rough edge so the end panel doesn't sit inside that surely?
Asked by: gjgjgj
Which end panel matches this?
I bought this today with the “To go” end panel but the end panel is plain whereas this has a stepped lower section
Asked by: Duggy66
Hello Duggy66
With this bath the end panel has always been plan so it can slot over the front bath panel and hide the internal edge, a stepped panel wouldn't fit this type of system.
Thank you for using the Screwfix Q&A service
Answered by: Jclarke71
Date published: 2022-01-24
Flat or curved?
Is the panel flat faced or curved. One question Screwfix have answered as curved and one question they have answered as flat
Asked by: K6vvr
Hello K6vvr,
This is a flat panel.
Thank you for using Q&A.
Answered by: LMARSH
Date published: 2022-03-07