Evo-Stik Polyurethane Wood Adhesive 310ml (40778)

Yes it is suitable for that substrate. But it will expand and would need clamping when it is curing under load, it is a coloured product.

Unfortunately the 'Evo-Stik Polyurethane Wood Adhesive' will not work for this application as it will not bond to the High-density polyethylene (HDPE). The 'Evo-Stik Polyurethane Wood Adhesive' will not work on the following materials; polythene (polyethylene), polypropylene, EPDM rubber, Teflon and some engineering plastics such as nylon.

The Evo-Stik Polyurethane Wood Adhesive is primarily designed for bonding wood to wood but can also be used for bonding other materials such as metal, concrete, plaster and brick as long as one of the materials being bonded is porous. Once applied to a joint and after bonding, the application requires clamping as the product does foam, however the bond line needs to be kept thin to achieve in service strength and so this quality does not enable the product to have a gap filling property. Outside of this, whilst the product is waterproof once cured and in service ( so it can be used for suitable exterior applications ) it is not designed or specified in general for boat applications including construction or repair and so it is not recommended for use in this case. Instead a suitable adhesive specified for marine and boat applications will be required.

The Evo-Stik Polyurethane Wood Adhesive is a moisture curing adhesive that can be used for bonding wood and will bond to other materials such as metal, concrete, plaster and brick. The product has an unopened shelf life of one year, however, once opened and the original seal is broken, the shelf life is much more limited as exposure to to the air will start to cure the product from the top of the nozzle downwards. This cannot be stopped as such but it could be slowed down, for instance by wrapping the cartridge with cling film and using elastic bands, particularly at the nozzle end so that the product is made as air tight as possible.If it has cured in the nozzle, it may still be possible that the adhesive is still uncured in the cartridge itself and so fitting a new replacement nozzle could mean that the remaining product is still usable. Outside of this,it is difficult to say what the longevity of the product will be once opened as it can vary due to local conditions but it would be measured in terms of a few weeks maximum rather than months

The Evo-Stik Wood Adhesive Polyurethane 310 ml is a moisture curing single part resin product primarily designed for bonding wood to wood but can also be used for bonding wood to other surfaces such as concrete, metal, brick and some plastics although you need to ensure that at least one of the surfaces being bonded is porous. As such whilst the product can bond wood to concrete in general, as with any application, during curing, it needs to be clamped or be put under load which is generally not practical for flooring. Consequently for a flooring application where plywood is being bonded to concrete a suitable flooring adhesive would normally be used.