What additional parts do I need to connect this drill bit to my drill to cut a hole through a cavity wall
I believe I may need an extension and arbor to drill through a cavity wall. What part numbers do I need?
Asked by: 33john
Hello 33john,
You will need an arbor, either Erbauer Diamond Core Hex Arbor 90mm (2091V) or Erbauer Diamond Core SDS Plus Arbor 115mm (8666V) depending on your drill. The Erbauer Diamond Core Extension 200mm (8561V) and the Erbauer Diamond Core 8mm Pilot Drill 205mm (1601V) would then also be needed.
Thank you for using Q&A
Answered by: SWake
Date published: 2021-02-24
Suitable for groundwork stone
I need to dig holes into hard ground stone by a pavement for 6" depth border fencing. I've hammered at it with a heavy pickaxe, and there must be an easier way, short of pneumatic drill hire. Is this bit up to the task?
Asked by: Denigor777
Hello Denigor777,
This will depend a lot on the stone. This bit can be used on things like poured concrete without reinforcement, bricks and concrete blocks but if you have a natural hard stone like granite then it may struggle. You will also need a good SDS drill to use this bit with, a combi drill won't do it.
Thank you for using Q&A
Answered by: Cwalm
Date published: 2020-09-16
Diamond Core Drill, wet or dry?
When using this type of drill do you use water or not?
Asked by: Rotter
Hello Rotter,
These are suitable for wet and dry cutting.
Thank you for using Q&A
SW
Answered by: SWake
Date published: 2020-08-16
