Appleby 2 + 1-Gang Dry Lining Knockout Box 35mm (60079)

Hello. In principle, it is ok for the AC and DC current/power products to be installed in the same box compartment and then data in a separate compartment as they are separated by the plastic barrier in the middle of the box. This in theory reduces the risk of electronic noise or other interferences that can affect the data output. Regarding the legality and safety of the installation as we are unaware of the environmental conditions of the installation such as cable size, quality, back up protection device etc, we advise contacting a qualified electrician. Thank you for your interest in our appleby brand.

Hello. Cut out dimensions are: 158mm x 73mm. Thank you for your interest in our appleby brand.

Hello. Whether there is sufficient clearance or not depends on the overall size of the plates. To be sure, we would need to understand which switches are going to be used because dimensions are a key factor here. Depending on size there may be clearance but, if there is, there wouldn’t be much leeway. Thank you for your interest in our appleby brand.

Hello. Unfortunately we cannot comment on competitor products but thank you for your interest in our appleby brand.

Hello. We are assuming that the dimensions required is relative to the actual fixing lugs of the accessory… If so we would advise that the maximum depth in which the lugs will go to is 15mm. The minimum partition thickness is 6.35mm. Thank you for your interest in our appleby brand.