Zinsser Self-Priming Paint Satin White 1Ltr (13040)

Hello Thank you for your enquiry. If the bath panel has been previously painted then the self-priming paint may be applied direct, however if this is bare mdf then two coats of Bulls Eye 123 primer/sealer (10135 & 10136) should be applied prior to the top coat. Two coats of the Bulls Eye 123 would need to be applied by brush or roller at a coverage rate of approximately 10m2/L/coat with a re-coat time of 1 hour. I hope this helps.

Hello Thank you for your enquiry. Mixing an alternative paint into the Perma-White is not something we would recommend as this will likely have a different formula to our paint and may change the properties of the paint. Our recommendation would be to use a paint of the colour required. I hope this helps.

Hello Thank you for your enquiry. Perma-White self priming paint will be perfect for application to your bathroom ceiling. Two coats would need to be applied by brush or roller at coverage rate of approximately 10m2/litre/coat, with a re-coat time of 2 hours in normal drying conditions. If the surface this is to be applied to is bare plaster, a suitable primer shoudl be used such as Bulls Eye 123 (10135). any loose r flaky paint should be taken back to a sound, feather edged surface. Once this has been achieved and the area has been cleaned and is dry, you may apply your first coat of Perma-White. I hope this helps.

Hello Thank you for your enquiry. Perma-White can be applied directly to the previously painted surface in two coats. This should be applied by brush or roller at a coverage rate of approximately 10m2/litre/coat, with a re-coat time of approximately 2 hours. While no sanding is required before applying the Perma-White, if the surface is glossy, a light abrade would assist the paint to adhere. We recommend to ensure the surface to be painted is clean, dry, sound and free from any surface contamination such as dirt, oils, grease, mould, mildew, rust, loose or flaking paint etc that are likely to affect the performance of any subsequent coats of paint; to ensure this we advise the following prior to painting, clean down with hot soapy water, rinse with warm water and when dry have a good wipe over with methylated spirits to promote good adhesion. I hope this helps.

Hello Thank you for your recent enquiry. Zinsser Self-Priming paint is able to be applied over a previously painted surface, providing this is sound and clean, reaching full cure after 7 days. We are confident the product is fit for purpose, however if you are still experiencing this problem once full cure has been reached, please contact us at techsupport@tor-coatings.com I hope this helps.