Zinsser All Coat Exterior Paint White 1Ltr (5946G)

Hi. Thanks for your enquiry. We would not normally recommend using sugar soap for preparing a surface ready for painting. A proprietary cleaner would be recommended or alternatively hot soapy water then rinse with fresh warm water to remove detergent and when dry a good wipe with methylated spirit. As UPVC surfaces tend to have a wax like finish we would also advise lightly abrading the surface area. I hope this helps.

Hi. Thanks for your enquiry. The All Coat Exterior paint is suitable for direct application to clean metal but not in surfaces where it would be submerged or have prolonged contact with water, so for the outside of the bath yes, it can be used for decoration only but not recommended for the inside. I hope this helps.

Hello Thank you for your enquiry. AllCoat Exterior can be applied directly to a variety of substrates including wood, however there is no stain blocker in this paint to prevent any staining from the tantalised wood and we would recommend using a stain blocking primer for this project. Our recommended primer for this would be Cover Stain (17114). One or two coats of the primer should be applied by brush or roller at a coverage rate of approximately 10m2/litre/coat, with a re-coat time of 2 hours. Once this has dried, the AllCoat would be perfect to be applied to this in two coats. I hope this helps.

Hi Kazu. Thanks for your enquiry. Yes, the All Coat is suitable on interior surfaces including standard, water-filled radiators. Two coats are required as normal to a suitably prepared surfaces i.e. sracping off anything loose and flaking and a thorough clean down with a strong solvent such as methylated spirit I hope this helps.

Hello Thank you for your enquiry. You won't need to strip the paint from the door as the AllCoat will cover this, due to the depth of colour you are looking to over-coat you may need to apply more than the two coats advised. Before painting, you will need to ensure the substrate is sound and clean, removing any loose or flaky paint and giving the area a good wash with hot soapy water, rinsing with warm then wiping with methylated spirits if possible. I hope this helps.