Extended Hours! Stores open until 8pm Mon-Fri

Stuart Turner Showermate TP S Centrifugal Shower… (6515D)

£ 99.98INC VAT

Add to basket for...

Stuart Turner Showermate TP S Centrifugal Shower Pump 2.0bar (6515D)

Positive head. 2.0bar. High quality plastic pump designed to improve water supplies to single taps or pump blended water from a shower mixer. For installation advice call PumpAssist 0800 31 969 80.

  • Positive Head
  • Suitable for Gravity-Fed Systems
  • Up to 1 Connectable Showers
  • 15mm Push-Fit Anti-Vibration Couplers
  • 30min On / 30min Off at 9Ltr/min
  • Plastic
  • 1 Year Guarantee
  • Quiet Operation
  • Centrifugal Design

More Info

View all: Stuart Turner Shower Pumps

£99.98INC VAT

Add to basket for...

Stuart Turner Showermate TP S Centrifugal Shower Pump 2.0bar is rated 3.7 out of 5 by 6.
  • y_2020, m_9, d_21, h_15
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.12
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_6
  • loc_en_GB, sid_6515D, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getAggregateRating, 22ms
  • REVIEWS, PRODUCT

Add to saved list...

Save
Rated 5 out of 5 by from One happy customer Recently I did a complete bathroom refit, which included fitting a shower pump. It needed a new cylinder, as the existing one was almost half full with scale. So I was asked to replace the cyl as well. Although the flow to the bath and sink was just about okay, due to the small head (it being a bungalow) it wasn't sufficient to hold the valve open on the hand held shower spray, which was part of the bath taps. So the customer wanted this sorting. This pump was easy to fit, it took me less than 2 hours, and works brilliantly. Great flow, very quiet and the customer now has good hot water flow at all of his taps, and the valve now stays open on the shower spray. The only negative thing, is that it comes with 15mm push fit connectors, and I connected it into the 22mm hot water feed from the cylinder. I got round this by using a pair of 22mm flexible push fit connectors, which I had in stock. It would be good if the pump came with both 22 & 15mm connectors, but then guess it would be more money! The customer now has 2 pumps and is very happy Would definitely buy again. 5 stars
Date published: 2019-03-03
Rated 1 out of 5 by from Pump failed after 3 months Disappointing.......we installed this pump to the manufacturers guidance in March 2016 and have now had to replace the pump in June 2016. When first installed it seemed somewhat nosier than the stated 'from 50dB' but just accepted it as I am no expert on dB levels. After a couple of weeks we noticed some of spots of oil or grease in the water which had passed through the pump. After a month the pump grew noisier. After a couple of months the pump grew even noisier with a mechanical grinding sound whilst operating. After three months it was so noisy we had to buy a replacement pump as it sounded like it was going to fail imminently. I can only guess that the bearings tore themselves to pieces to achieve the impressive bag of spanners in the washing machine sound at the end of its short life. Have replaced now with the Salamander CT50+ Xtra and I have to be honest it is quieter than the Stuart Turner pump when new. ScrewFix customer service in resolving this however was faultless.
Date published: 2016-06-27
Rated 2 out of 5 by from disappointed with pump This pump was fitted last October, but it started to make too much noise and this morning it stopped working, I left it switched on for a couple of minutes and it did finally function. It does seem to have failed very soon after purchase.
Date published: 2016-03-31
Rated 4 out of 5 by from Quick service. Hi Ordered online and collected from Guisborough the following day. Friendly and efficient staff. In and out with my pump in minutes. Fitted and up and running in about an hour.
Date published: 2015-10-20
  • y_2020, m_9, d_21, h_15
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.12
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_6
  • loc_en_GB, sid_6515D, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getReviews, 106ms
  • REVIEWS, PRODUCT

Traditional hot water tank

The hot water cistern is on the ground floor. Would this be suitable to be fitted at first floor level on the rising hot supply for a shower?
Asked by: Dizzymole

What's minimum head needed

Electric shower in upstairs bathroom and header tank in loft.
Asked by: Timjbo

Can this run an electric shower

Can I put this on a cold feed to an electric shower to boost the pressure of the mains feed.
Asked by: Timjbo
Hello Timjbo, Unfortunately no! Techflo pumps are designed for use with 'Gravity Fed' plumbing systems where the cold water is supplied under low pressure from a cold water tank, usually located in the loft. If you want to boost the pressure of the mains cold water supply you should consider the Stuart Turner Flomate pump. This pump can be connected directly to the cold water rising main where it enters the property and after the stop-tap (often under the kitchen sink). In this way the Flomate will boost the water pressure to the entire property, your electric shower included. However, if this is not practical, the Flomate pump could just be installed in line with the cold water mains supply to the electric shower.
Answered by: stuart-turner pumpassist
Date published: 2019-06-03

Where is the location of 15mm isolating valve for this pump?

Asked by: bigshower
Hello. Unfortunately it appears that there is a small error on the product description - this product is not supplied with isolating valves. We will get the description updated, but in this case if you contact me directly on 01491 572655 and ask for David Roome I will happily send you some suitable isolating valves.
Answered by: stuart-turner pumpassist
Date published: 2015-11-24
  • y_2020, m_9, d_21, h_15CST
  • bvseo_bulk, prod_bvqa, vn_bulk_3.0.12
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_4
  • loc_en_GB, sid_6515D, prod, sort_[SortEntry(order=LOCALE, direction=DESCENDING), SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getReviews, 114ms
  • QUESTIONS, PRODUCT
  • bvseo-msg: BV SEO Content for this product did not include verbose reviews.;
Specification
Advisory Notice Must not be connected directly to mains water supply.
Bar Pressure 2.0 bar
Brand Stuart Turner
CE Standard (Tested to EN...) BS EN 60335-2-41.
Connection Type 15mm Push-Fit Anti-Vibration Couplers
Construction Material (Bathrooms) Plastic
Gravity Fed Systems Suitable for Gravity-Fed Systems
Impeller Type Single
IP Rating IPX2
Manufacturer Guarantee 1 Year Guarantee
Max. No. Of Connectable Showers 1
Max. Pump Flow Rate 17 Ltr/min
Min Pump Flow Rate 0.8 Ltr/min
Model No Showermate TP S
Noise Level at 1m 56 dBA
Pack Size 1
Parent Colour Black
Pieces in Pack/Case 1
Product Height 152 mm
Product Length 228 mm
Product Type Shower Pump
Product Width 97 mm
Pump Head Type Positive Head
Pump Type Centrifugal
Total Product Weight 2.5 kg

Product contents

Pump, inlet hose, outlet hose with integral washer and filter washer.

Downloads

Instruction Manual