Sprung Bath Waste (47707)

£ 24.99INC VAT

Add to basket for...

Sprung Bath Waste (47707)

Modern bath waste with Chrome-plated brass top. Internal spring plug pops up and down with each press. No need for chain. Supplied with domed chain hole stopper.

More Info

View all: Essentials Wastes

Bulk Save Save up to 5%
Bulk savings
QTY Price per item Saving
1 - 3 £24.99 -
4 + £23.74 Save 5%
£24.99INC VAT

Add to basket for...

Add to saved list...

Save
Rated 1 out of 5 by from Poor quality item Seemed OK getting it out box and was professionally installed. Part failed within a week, water leaking from area at end of cable mechanism and plug didn't seal properly..I now have a water stained frontroom ceiling and have had to buy a better product and pay for it to be installed.
Date published: 2022-08-19
Rated 1 out of 5 by from Awful Awful Awful This is the worst plumbing product I have ever purchased. Who ever designed this should hand their notice in with immediate effect. Where do I start…. A component that needs to be water tight, which isn’t! If your not prepared to bodge this in with a boat load of silicone then be prepared for leaks at multiple points. Cut outs for an overflow that don’t even marry up. An overflow pipe that guess what????…. LEAKS…. as it’s reliant on the thinnest of o-rings. Grab your silicone gun and give another pull on the trigger here because it’s going to be the only way seal this sucker up! Then once you’ve done sealing every component and washer up, you get a weep down the thread unless your prepared to give this another smear of the good stuff!!! This really is the pits!! What ever happened to one moulded unit, with a compression overflow, a threaded bolt for tightening, a couple of washers to achieve leak free status and a straight forward plumbing job, achieved with minimum fuss and no silicone!! 0 STARS from me!
Date published: 2022-08-11
Rated 1 out of 5 by from Bit of a bad design Difficult to seal up properly. Not the best design
Date published: 2022-07-11
Rated 1 out of 5 by from Be good to yourself. Be good to yourself and don't buy this rubbish. So poorly designed. Out of the box it looks very good quality but don't be fooled. The instructions state not to use anything that hasn't been supplied. I had to put PTFE tape on the threads as water collects in the boss and drains down the threads. It employs a plastic nut on metal threads never a good idea. I eventually got it to seal by applying silicone on all the seals. Low and behold the overflow pipe where it enters the boss then leaked. It's just a plastic pipe with an O ring on the boss instead of a threaded connector and seal. More silicone!! This thing has cost me so much time and trouble. I should have taken it back. Don't buy it and you won't have to take it back!!
Date published: 2022-04-26
  • y_2022, m_9, d_29, h_21
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.34
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_166
  • loc_en_GB, sid_47707, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getReviews, 10ms
  • REVIEWS, PRODUCT

What bath trap would fit this ?

Asked by: Soopyg
Hello Soopyg, Any 40mm bath trap we sell would have the correct connection to screw on to the bottom of this waste. Thank you for using Q&A
Answered by: Cwalm
Date published: 2022-02-12

My bath is 28 mm at the wast and 12mm at the overflow are the screws long enough for this?

Asked by: Stephensimm
No, I've just tried fitting to 14mm thick bath and the overflow thread is too short and the waste does not project enough at the bottom of the bath to fully fit the adaptor over the overflow slot.
Answered by: Brummers
Date published: 2021-09-30

the current waste outlet measures 45mm. Will this item accommodate the difference?

Asked by: Kleg
Hello Kleg, Unfortunately this item is not fit for your needs. Thank you for using Screwfix Q&A. A.K.C.
Answered by: AliScrewfix1
Date published: 2022-07-10

My bath top is 70mm

Do it fix my bath top is 70mm in dimension ?
Asked by: Atchap
Hello Atchap, The pipe is 450mm in length and the wasteb has a diameter of 40mm. Thank you for using Q&A SW
Answered by: SWake
Date published: 2020-09-11

Is the rubber gasket available that fits under the steel plug as its letting water out of the bath.

Asked by: Vauxman
Hello Vauxman, This is not something that we stock as a separate part. Thank you for using Q&A SW
Answered by: SWake
Date published: 2022-06-11
  • y_2022, m_9, d_29, h_21CST
  • bvseo_bulk, prod_bvqa, vn_bulk_3.0.34
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_14
  • loc_en_GB, sid_47707, prod, sort_[SortEntry(order=LOCALE, direction=DESCENDING), SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getReviews, 10ms
  • QUESTIONS, PRODUCT
  • bvseo-msg: BV SEO Content for this product did not include verbose reviews.;
Specification
Brand Essentials
Colour Chrome-Plated
Manufacturer Guarantee 1 Year Guarantee
Pack Size 1
Parent Colour Silver
Pieces in Pack/Case 1
Product Diameter 40 mm
Product Type Sprung Bath Waste
Waste/Plug Type Pop Up
Waste Location Type Bath

Downloads

Instruction Manual