Would it work for supply pressure below 0.1 bar
I had Grohe inlet valve which worked fine with low pressure of 2+ feet for years, would this work as replacement. If not any alternative, please.
Asked by: Purush
Hello Purush,
Yes, this can be used on low pressure systems.
Thank you for using Q&A
Answered by: SWake
Date published: 2021-06-17
Where is the filling tube?
This product is showing it should include the filling tube, the tube is shown on the picture on the website and also in the instruction manual but not included in the item pack?
Asked by: megmog
Hello megmog,
Due to a change in regulations the tube, which acted like a silencer and stopped the water splashing, had to be removed.
Thank you for using Q&A
Answered by: Cwalm
Date published: 2021-08-28
Thomas Dudley Vantage
Have a TD Vantage concealed cistern with side-entry Hyroflo. Float level arm isn't cutting off inlet valve and think the diaphragm is faulty.
Would this fit the TD Vantage?
Thanks.
Asked by: KSBird
Hello there,
If the fittings match then this should work, however. We would advise going to a suitable tradesperson or going directly to the supplier to confirm this.
Thank you for using Q&A
TC
Answered by: TChanning
Date published: 2019-01-12
Adjusting the float height
How is the float height adjusted please?
I can see the notches on the rod connected to the float but can not move them through the connector on the float arm. Not helped by being a concealed cistern so difficult to see!
Asked by: Moiaussi
Hello Moiaussi,
It would be best to contact as qualified tradesperson to assist you with the installation of this item
Thank you for using Q&A
SW
Answered by: SWake
Date published: 2020-12-18
