Does this require a 115mm hole cut out for fitting?
Asked by: JonnyK1992
Led light? Transformer NOT required? Led keeps tripping
I purchased not knowing that the bulb included needed another power source as it is a 12V LED? where does the LED 12V get it's power?
It keeps throwing the trip?
Can I replace with a 240V MR16 LED bulb and hard wire too the switch?
Asked by: JustWantItWorking
says zone 2, however above shower is zone 1 ?
i notice this is adverstised as a shower light fan, however, the spec says it is for zone 2, whereas above a shower is zone 1.
is this suitable for above shower in a zone 1?
am i wrong somewhere ?
ta
Asked by: gingle
You are correct if below 225 cm height. However,Zone 2 applies over 225 cm (which is higher than a standard ceiling height.)
Answered by: cudgeon
Date published: 2020-11-22
Replacement LED lamp
Can anyone recommend a replacement LED lamp? I have used LAP one from screwfix, but they constantly flash, putting the original lamp in from a second fan and it is okay, indication that the LAP LEDs are incompatible with the LED driver.
Asked by: Derbys
Duct length
What is the purpose of having a minimum of 500mm before and after the fan? Also can the fan be mounted with its axis vertical?
Asked by: JollyMiller