Remove handle?
I'd like to remove the handle (& leave it off) so I can give it a good level of insulation along with pipework either side.
But it looks like there's a white gland underneath and wondering if I need to leave it in place to keep it water tight?
Asked by: Mikrt
Hello Mikrt,
Thank you for your enquiry.
As you will be removing the handle, (and leaving it off) have you considered something like DOUBLE CHECK VALVE DZR 22MM (26003)?
Thank you for using Q&A.
Answered by: Screwfix778
Date published: 2020-12-22
Does it's manufacture add to climate change?
Is it made with fossil fuel such as coal, oil or gas, or is it made using nuclear, wind, tide or solar energy? We have a climate emergency.
Asked by: CityBeekeeper
Hello,
We have no information in regards to how these are made,
Thank you for using Q&A
KD
Answered by: Kdavis10
Date published: 2020-01-05
Is the compression thread the same as a BSP screw fitting?
Can I use an adaptor to convert the connection from compression to a push fit option using something like screwfix part: 1026F. Screwing the BSP threaded end onto the thread which would usually take the compression nut?
Asked by: Puffafish
Ive checked mine and is not 3/4 bsp thread
Answered by: AndyRepairs
Date published: 2020-12-08