Gripfill Adhesive 350ml (10261)

The Evo-Stik Gripfill Adhesive 350 ml is a solvent based rubber resin grab adhesive that will bond materials such as wood, metal, plasterboard and some plastics among others in suitable applications. Once applied to one surface in beads, and after bonding has taken place ( where there beads are flattened to a thin film ), it dries by the evaporation of the solvent out of it over a period of 24 hours typically. When wet, the product is flammable which is due to the solvent component of the product, with the solvent being required to the make the adhesive soft so that it can be extruded through the cartridge and be applied and initially stick to the substrates it is applied to. The solvent then evaporates away leaving the remaining part of the adhesive doing the actual bonding when in service. Once dry it will not be flammable and it will have a temperature resistance of up to + 70 ° C, however exact drying time can depend on local conditions as well as the type of substrates and adhesive thickness. As such potentially, there could be a small amount residual solvent left for a while after the typical drying time. Alternatively, the Evo-Sticks Like range of grab adhesives could be considered as they do not contain solvent and have a greater temperature resistance once cured of + 100 ° C.

The Evo-Stik Gripfill Adhesive is a solvent based rubber resin type of grab adhesive that will bond to materials such as wood, metal, plaster. plasterboard, concrete and some plastics among others. As such the product will give a bond between a cement based screed or concrete and plywood, however ( whilst it is sometimes used for bonding carpet grippers to sub floors ) it is not generally used for this type of floor construction as such, and so such an application is not generally recommended, especially if further flooring is to be applied on top. ( Normally for such a flooring requirement, the plywood would be mechanically fixed.)

Thank you for your questions relating to our Evostik Gripfill. From the details supplied we would not recommend Gripfill for this application but instead would be suggesting the use of a cement based tile adhesive designed for use with Porcelain Tiles.

Thank you for your recent enquiry into our Evostik Gripfill. I can confirm that Gripfill is not designed to be waterproof, we do state that the adhesive can be used externally if the bond is protected. I trust this information helps.

Thank you for your enquiry relating to our Evostik Gripfill. For our Gripfill to work successfully one surface should be porous i.e bare wood, concrete or plaster. Second to this composite decking can include polypropylene or polyethylene and unfortunately Gripfill will not bond these types of plastic. I hope this information helps.