Can this be used in the domestic hot water feed pipe from hot water cylinder to taps to prevent air locks?
Will be a temporary installation in place for a few weeks where this pipe run would have a rise and fall creating a vertical loop between 300 and 600mm high with nowhere to vent to otherwise
Asked by: BCeng
Hello BCeng,
Screwfix are not able to offer specific plumbing/installation advice and always recommend speaking with a suitably qualified tradesperson.
Thank you for using Screwfix Q&A.
Answered by: AMargetts
Date published: 2022-06-12
Bottle Air Vent or End Feed Air Vent Cap Capillary
My End Feed Air Vent Cap needs replaced. Can I use the Bottle Air Vent? The compression joint of the Bottle Vent is easier than needing to fully drain the system so I can solder the other type on.
Asked by: Scott2012
Hello,
Thank you for your enquiry.
Screwfix are not able to offer specific plumbing/installation advice and always recommend speaking with a suitably qualified tradesperson.
Thank you for using Q&A.
Answered by: Screwfix778
Date published: 2021-02-25
How many needed?
I have air in my central heating system. We removed a radiator from the loft as it was no longer needed. Do I need 2 of these for each pipe left up there or just the 1?
Asked by: Stephen2016
Hello Stephen2016,
We are not able to advise you on this and would recommend you speak to a qualified tradesperson.
Thank you for using Q&A
SW
Answered by: SWake
Date published: 2020-07-15