QEP Heavy Duty Tile Cutter 630mm (29758)

To my amazement, it cuts an unpolished porcelain limestone effect tile with lots of porous holes perfectly. I tend to give 3 high pressure passes of the wheel before breaking near to the far end, paying particular attention to deep scoring the edges of the tile, where it is easy to under-score. It also gives perfect edges with no far end spalling on matt heavily textured wood effect porcelain tiles using a similar method. All these tiles were 10mm thick. It's much quicker and cleaner than a wet saw.

Good afternoon, Thank you for your enquiry. We would not advise using this manual tile cutter for cutting marble. For this job we would advise using an electric wet saw to ensure clean and accurate cuts. Thank you

Good morning, Thank you for your enquiry. The spare wheel for this machine is Vitrex 102385 - Replacement Wheel Kit for 102380 / 90. Kind Regards

Dear Paul, Thank you for your enquiry. As per specification, this machine will cut tiles up to 14mm thick and up to 630mm long. It should dry cut fine, you can always roll the wheel back and forward a few times over the ends if there's any need. Thank you

No. It can't remove a square from a corner. However with some experience, it can do the final cut for such a double cut. i.e. you can use a wet saw or angle grinder to do the shorter cut and use this to complete the longer cut.