Flickering
I have recently attempted to use these to replace some Halogen bulbs but when powered on the bulbs flickered.
I then tried replacing the old transformer with 92658 but had the same issue.
Any bright ideas to help illuminate the situation?
Asked by: Chrisshortys
Hello there,
We would recommend you contact a local trades person who will be able to confirm the circuit and all components are suitable for this type of bulb as there are a lot of variables involved.
Thank you for using Screwfix Q&A.
Answered by: HTrowbridge1
Date published: 2020-11-07
Are these "retrofit" and compatible with an existing low voltage transformer?
Hi,
I'd like to upgrade the to led, but i don't know where the remote transformer is located. Can i just remove the halogen lamps and install these led ones, utilising the existing 12v transformer?
Asked by: Taurusboy
Hello Taurusboy,
These are not a retrofit lamp and you may need to change your transformer.
Thank you for using Q&A
Answered by: Cwalm
Date published: 2021-01-28
Do these need DC or special transformer?
I have tried these as a replacement for halogens and they were not very bright. I am assuming that either they are not drawing enough current for the voltage dropper/ transformer to work properly or they need DC.
Asked by: MCBB
Hello there,
These should work fine aslong as they are in the correct cap and the transformer can provide the wattage for these bulbs.
Thank you for using Screwfix Q&A.
Answered by: HTrowbridge1
Date published: 2020-11-28
Can you confirm diameter and length?
Question has already been raised by another earlier this month - but not fully answered.
What are the correct dimensions for diameter and length of bulb? Surely not 39mm diameter as I doubt would fit many G4 fittings.
Asked by: Whatsbrokennow
Hello Whatsbrokennow,
The measurements listed are the wrong way round. I have requested this be changed. This product is 10mm diameter and 38mm in length including the pins.
Thank you for using Q&A (CW)
Answered by: Cwalm
Date published: 2020-10-04
