British General Plastic Cable Gland Kit 20mm (8797P)

Hi Beastman, This cable gland (our code CPRGPF20) has been designed specifically for use with standard tein and eartn (T&E) cable with core sizes in the range of 2.5 - 4 mm² cross-sectional area (CSA) which it is very likely that LED lighting ribbon cable is significantly smaller than so would not allow the gland to seal properly around it.

Hi WeAreElectric, The spec of our Plastic Cable Gland kits doesn't include any component identified as a rubber sleeve, although the tails glands do come with a plastic rod to insert in the Earth wire hole if it isn't being used, so in order to ensure we are answering about the part you are referring to we will need to see a picture of it. You can send a picture to us direct at:- technical.support@bgelectrical.co.uk

Hi sunlightcity, As the insert is only intended for up to 4mm cable we would not advise trying to squeeze 6mm in as this will; distort the rubber insert and may result in the gland nut not tightening down as it needs to in order to make the correct seal.

Hi mdr75, These glands have a 20mm diameter thread, so yes they will fit a standard 20mm knockout in a back-box.

Hi Pz648, The aperture dimensions for the grommet insert are 13mm x 7mm.