Can you use solder of these if leaking?
I have a tiny leek on the 22mm pushfit. It is definitely fully inserted. I can only assume either the pipe is a poor cut or the pushfit is faulty. Either way, is it possible to solder the pushfit to the pipe to stop the leek?
Asked by: Jdts
I’d imagine not as there is a small rubber o ring internally. Just need to make sure pipe is clean, chamfered & deburred.
Answered by: Roverspete
Date published: 2020-08-18
How far does the pipe end push into the coupler?
Trying to fit a T piece in the middle of an exisiting length of pipe. Need to know how much to cut out...
Asked by: P4U1
Site says:
Pipe size - Depth once inserted.
10mm - 15mm
15mm - 16mm
22mm- 18mm
28mm - 20mm
Answered by: Roverspete
Date published: 2021-12-23