How flexible is this trunking?
Specifically, if I have a 1330 mm length, lying flat on a table, would I be able to displace the centre by 90 mm while keeping it flat on the table? That is, the displacement is in the direction of the 100 mm dimension, not the 25 mm dimension. Thanks!
Asked by: NofA
Thank you for the enquiry this will not bend that far
Answered by: SchneiderElectric Support
Date published: 2020-06-26
What are the internal dimensions and why can you not put heating pipes in the trucking?
What are the internal dimensions, depth and height of each section, and why does another answer say heating pipes cannot be installed in the trunking?
Asked by: ggpowell2
Thank you for your inquiry. the internal measurements for the Tower 100 x 25mm trunking are approximately top section 22 x 18mm , middle 45 x 18mm and bottom 20 x 18mm. Max operating temperature is +60°C, and along with the expansion and contraction – it is not suitable for heating pipes.
Answered by: SchneiderElectric Support
Date published: 2019-09-03
How does this ‘accept’ the surface boxes
I don’t see how I can install the surface boxes into the trunking
Asked by: Scottie86
Thank you for the enquiry you will need to purchase mini trunking adaptor to attached a surface box.
Answered by: SchneiderElectric Support
Date published: 2019-12-03
Heating pipes
Is it possible to run 2 x 15mm copper pipes in this trunking?
Asked by: Fishybits
Thank you for the enquiry we would not recommend heating the conduit using copper pipes between it, cables
Answered by: SchneiderElectric Support
Date published: 2018-02-04