Browse store

Triton Enrich Manual Electric Shower White 9.5kW (74867)

Electric shower featuring multiple cable and water entry points for ease of installation. Simple dial controls for temperature and pressure settings. Supplied with 1m stainless steel chrome hose and adjustable riser rail with shower head holder.

  • Single Control for Start / Stop & Power Selection
  • Single-Spray Pattern Shower Head
  • 2 Year Manufacturer's Guarantee (T&Cs Apply)
  • Eco Setting
  • Water Efficient
  • Manual Temperature Control
  • Rotary Power Control
  • Rotary Heat Control with Dial Settings
  • Rub-Clean Shower Head

More Info

£59.99INC VAT

Add to basket for...

Triton Enrich Manual Electric Shower White 9.5kW is rated 4.4 out of 5 by 98.
  • y_2017, m_2, d_20, h_11
  • bvseo_bulk, prod_bvrr, vn_bulk_0.0
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_98
  • loc_en_GB, sid_74867, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix

Add to saved list...

Save
Rated 5 out of 5 by from A quality buy First one I bought lasted 15 years.so I knew I would be on a winner buying the same model no complications it fitted on the existing fittings and no mess so easy.
Date published: 2017-02-16
Rated 5 out of 5 by from Value product This product is excellent in its performance gives you just what you require. Good quality
Date published: 2016-12-23
Rated 5 out of 5 by from Good quality Easy to install, reasonably priced with good performance Would recommend as I have fitted quite a few now
Date published: 2016-12-11
Rated 5 out of 5 by from Good product If you cannot afford to upgrade to a 10KW shower because it requires a 10mm T&E supply cable, then this is the maximum KW that can be used with a 6mm T&E cable. Just make sure that it is RCD or RCBO protected with appropriate dedicated earth cable direct from the shower to the consumer unit.
Date published: 2016-12-03
  • y_2017, m_2, d_20, h_11
  • bvseo_bulk, prod_bvrr, vn_bulk_0.0
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_98
  • loc_en_GB, sid_74867, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix

I have a aqualisa electric shower would this be a easy replacement

Asked by: Hambo40
Thank you for your recent enquiry. I am not too familiar with Aqualisa products as these are not manufactured by ourselves. The Enrich unit will have the water connection in the bottom right hand corner and the terminal block will be on the left hand side about half way down the unit. You could maybe check this against the existing product. care also is required in choosing the kw rating in order to ensure that the cable size and circuit protection is correct for the loading concerned. If upgrading then Part p Building Regs will need to be adhered to. I hope that this information is of help. Regards, Karl (TRITON SHOWERS).
Answered by: Anonymous
Date published: 2017-01-30

I have a triton enlight electric shower will this fit in it's place

Asked by: Qazmko
Thank you for your recent enquiry. The units do not share the same back plate so whilst the Enrich could be used some changes to the installation would be required. Location of the Terminal Block will differ as well as the orientation of the water connection. Care in selection of the kw rating will also be important to ensure that the cable size and circuit protection are correct for the loading concerned. Any upgrade will require Part P Building Regs to be adhered to. Best Regards, Karl.
Answered by: Anonymous
Date published: 2017-01-11

ive just installed this shower and am finding that it is very sensitive on the flow dial , if im not careful it will either scald me or freeze me any ideas?

Asked by: brian101068
Thank you for your recent enquiry, Generally with the symptoms that you have presented we would be looking at one or a combination of the following : Shower temperature set too high. Shower head blocked Hose blocked, twisted or kinked Inlet filter blocked General restriction of water flow to unit - isolation valves to unit not fully open etc Internal build up of scale /debris within unit. Water press Areas as listed above could be checked for any obstruction where possible and the unit could be flushed through on a cold setting with out the shower head in place. This will allow the full flow of water to be flushed through the unit and hose and hopefully flush through any loose debris. If necessary replacement parts can be ordered through our Spares Dept (Tel : 02476 378495 or via our Web Site). Alternatively arrangements could be made for one of our Service Engineer's to visit if you would prefer this course of action. I hope that this information is of help. Regards, Karl.
Answered by: Anonymous
Date published: 2017-01-05

Pump?

Is this with builtin booster pump to increase pressure?
Asked by: uktooler
Thank you for your recent e.mail. If the running pressure is below the minimum requirements (for a 9.5kw this would be 1 bar running pressure @ a min flow rate of 9 ltres per min) then adding the Pump would assist this problem. generally though you would need a gravity fed system to supply this type of installation. Adding a pump will not increase flow performance from an Electric Shower though as it will need to slow down the flow in order for the water to be heated. I hope that this information is of help. Regards, Karl.
Answered by: Anonymous
Date published: 2016-10-29

Is the connection for water feed 15mm or 22mm ?

Asked by: Stevieg92
Thank you or your recent enquiry, the inlet water feed on our Enrich Shower unit is 15mm. I hope that this informationis of help.
Answered by: Anonymous
Date published: 2016-12-07
  • y_2017, m_2, d_20, h_3CST
  • bvseo_bulk, prod_bvqa, vn_bulk_0.0
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_6
  • loc_en_GB, sid_74867, prod, sort_[SortEntry(order=LOCALE, direction=DESCENDING), SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
Specification
Brand Triton
Cable Entry Points Top, bottom, rear, left and right
Colour White
Manufacturer Guarantee 2 Year Manufacturer's Guarantee (T&Cs Apply)
Manufacturing Standards BEAB approved
Minimum Bar Pressure 1.0 bar
Model Name Enrich
Model No SFXENR09WC
No. of Spray Patterns Single-Spray Pattern
Pack Size 1
Pieces in Pack/Case 1
Pieces in Pack/Case 1
Power Control Type Rotary Power Control
Power Output (Watts/Kw) 9.5 kW
Product Depth 110 mm
Product Height 305 mm
Product Type Manual Electric Shower
Product Width 210 mm
Temperature Control Type Manual Temperature Control
Water Entry Points Right, left, top, bottom and rear

Control unit W x D x H: 210 x 110 x 305mm. Min. operating pressure: 1.0bar. Max. flow rate: 9Ltr/min. Model: SFXENR09WC. BEAB.

Product contents

Unit, riser rail, brackets, hose and showerhead.

Downloads

Instruction Manual