Browse store

Varilight Trailing Edge Push Dimmer 1G 1/2W 400W/VA (94816)

A wide range of dimmer to suit most applications from the UK's leading manufacturer. Suitable for domestic or commercial installations.

  • White Square Edged Plate
  • 1 Gang 400W for 1 / 2-Way Circuits
  • Co-Ordinating White Control Knob
  • Trailing Edge Technology
  • Intelligent Overload & Over Temperature Protection
  • Soft-Start Feature to Extend Bulb Life
  • Push On / Off with Rotary Dimming
  • Suitable for Mains / Low Voltage Lighting
  • Not Suitable for Wirewound Transformers & Fans

More Info

£14.36INC VAT

Add to basket for...

Varilight Trailing Edge Push Dimmer 1G 1/2W 400W/VA is rated 4.3 out of 5 by 61.
  • y_2017, m_2, d_15, h_19
  • bvseo_bulk, prod_bvrr, vn_bulk_0.0
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_61
  • loc_en_GB, sid_94816, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix

Add to saved list...

Save
Rated 5 out of 5 by from Dimmer switch Great value for the money works well would recommend
Date published: 2017-02-01
Rated 4 out of 5 by from LED's sorted Refurbishing a bathroom so replaced the old halogen downlighters with LED spots. Needed this dimmer to prevent the disco effect, straight swap, job done. Only put 3 stars for performance and reliability as job only done today.
Date published: 2017-01-16
Rated 5 out of 5 by from Replacement dimmer for LEDs Bought a few of these to control LEDs as my existing dimmers were not LED compatible. Simple to replace and work a treat. Depending on your make of LEDs you can change between Leading Edge or Trailing Edge mode. Dimming is smooth and no noticeable buzz from dimmer. As I have only had them for a short time, cannot comment on reliability.
Date published: 2016-12-10
Rated 5 out of 5 by from Best LED Dimmer Bought one of these to run 9 GU10 LED downlights, no flickering, nice large dimming range, easy to install & perfect for the job.
Date published: 2016-11-06
  • y_2017, m_2, d_15, h_19
  • bvseo_bulk, prod_bvrr, vn_bulk_0.0
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_61
  • loc_en_GB, sid_94816, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix

No instructions found on Varilight website on how to adjust dimmer for LED lamps. My sister has thrown the original instructions away and because the first lamps were non LED the problem of flickering didn't exist.

Just need basic instruction on how to adjust the dimmer?
Asked by: JJBoy
Hi JJBoy, thanks for your question. The instruction leaflet can be found on the Varilight website under Technical-Instruction Leaflets-V-Pro Intelligent Dimmers. You will want to look at the sections titled 'How to change your driving mode' and 'How to perform a factory reset'. Thanks for your interest in Varilight.
Answered by: Varilight Jen
Date published: 2017-02-03

Switch on state

When the knob is pushed to turn the lights on, do they come on at full power requiring you to turn them down, or do they come on at the level previously set prior to switch off?
Asked by: TheOldManse
Hello TheOldManse, thanks for your question. They come on at whatever level the knob is set to at the off position, full brightness, minimum brightness, or anywhere in between. Thanks for your interest in Varilight.
Answered by: Varilight Jen
Date published: 2017-01-23

Does this switch make the leds buzz?

Asked by: Westhammer
Hi Westhammer, thanks for your question. There is nothing in this dimmer that can make LEDs buzz, and if your LEDs are buzzing under any dimming load, there is a fault in that particular lamp, and should be replaced. Thanks for your interest in Varilight.
Answered by: Varilight Jen
Date published: 2017-01-10

Can this dimmer be used to dim an led gu10 spot and an incandescent lamp on the same switch

Asked by: Elec17
Hi Elec17, thanks for your question. We recommend for mixed loads to follow the LED load rating. Thanks for your interest in Varilight.
Answered by: Varilight Jen
Date published: 2016-12-27

How do you adjust this dimmer for LED lamps? I have this connected to 2 dimmable 7w lamps and it keeps flickering!

Asked by: JJBoy
Hi JJBoy, thanks for your question. You will find instructions on changing the driving mode on the instruction leaflet inside the packaging, there are also instruction leaflets available on the Varilight website. Thanks for your interest in Varilight.
Answered by: Varilight Jen
Date published: 2017-02-05
  • y_2017, m_2, d_19, h_4CST
  • bvseo_bulk, prod_bvqa, vn_bulk_0.0
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_9
  • loc_en_GB, sid_94816, prod, sort_[SortEntry(order=LOCALE, direction=DESCENDING), SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
Specification
Brand Varilight
Colour White
Fixings Supplied Fixings Supplied
Manufacturer Guarantee 1 Year Guarantee
Model No JQP401W
No. of Gangs 1
Overload Protection Thermal Overload Protection
Pack Size 1
Parent Colour White
Pieces in Pack/Case 1
Power Output (Watts/Kw) 400 W
Power Voltage Supply 220/250 V
Product Depth 45 mm
Product Height 85 mm
Product Type Dimmer Switch
Product Width 85 mm
Screwed/Screwless Screwed
Switches & Sockets Finish Plastic
Switches & Sockets Product Type Dimmer Switch
Switches & Sockets Profile Type Raised Square
Switch Type Dimmer
Total Product Weight 0.103 kg

Back box depth 25mm.

Downloads

Instruction Manual