Rated 2 out of 5Â by MDAG Too thick & not enough nozzles
This product was simply too hard to eject using a standard gun. It also would benefit from three nozzles per tube. It was difficult to fill and judge how full each hole was because of the high viscosity. Another brand was far easier.
8 Sep 2014
Rated 1 out of 5Â by silver73 Waste of money and time
Tried to use this to secure a wall plate. Glued one rod in, by the time I got to the second the resin had hardened in the nozzle. Tried to do it quicker with the spare nozzle and got the same result.
As the setting time of the resin is so quick at normal temperatures, it is my opinion that it is a waste of time using this.
26 Jun 2014
Rated 2 out of 5Â by Willbe Wrong formulation
This product goes off far too fast in normal temperatures. It seems to be designed for use in very cold conditions (-20C). I used it to fix some sleeve anchors into stone to hold gateposts outside in June - it was +20C. I am not very confident that the fixings I have made are sound. The label gives a working time of 2mins but in fact it was about 30 seconds and the resin gets very hot to touch. I wait to see if it has contracted away from the hole when it cooled. Even being very well prepared there is no time to check position, make sure the material is properly distributed and clean up the surplus and meanwhile the stuff in the nozzle is going off so you have to start on the next one immediately. It might be OK if put in the fridge for a few hours before use. The price is not very special - you can easily buy 380 ml cartridges of branded makes for only a pound or two more, but they need a larger cartidge gun which is not economic if you only want to use it once.
7 Jun 2014
Rated 4 out of 5Â by Cheamcyclist Does the Job
I used this product outside for fixing a gate post to a brick wall. I had no problems with the curing time. I then went to use the rest of the tube at least 1 year later, I found the spare nozzle Brock off the harden resin and it worked again perfectly, the time as anchor bolts for fence posts. Again I had no issues with the curing although I suspect the temperatures were much lower. I have not used any other resins to compare against but comparatively it is much cheaper and seems to do the job.
3 Jan 2014