Browse store

Galaxy GAP95 Powerstream Unvented Instant Water Heater 9.5kW (93177)

9.5kW. A space saving solution for providing instant hot water from the mains supply. Supplies 2 basins or 1 basin and 1 mixer shower. Half-power setting available. For use only with manual showers. For domestic use.

  • Water Outlet via Existing Tap or Mixer
  • Remote Fitting Option
  • No Standing Heat Loss
  • Unvented
  • Temperature Range:
  • Reheat Time:
  • Water Outlet via Existing Tap or Mixer
  • Remote Fitting Option
  • No Standing Heat Loss

More Info

£109.99INC VAT

Add to basket for...

Galaxy GAP95 Powerstream Unvented Instant Water Heater 9.5kW is rated 3.6 out of 5 by 13.
  • y_2017, m_3, d_20, h_14
  • bvseo_bulk, prod_bvrr, vn_bulk_1.0.0
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_13
  • loc_en_GB, sid_93177, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix

Add to saved list...

Save
Rated 5 out of 5 by from Great water heater Installed this water heater in the last few days, easy to install and set up for super hot water. The manufacturer stated it is not suitable for a kitchen but the one I have fitted is supplying hot water to my bathroom basin and kitchen sink, both are within 4 metres of each other. Make sure it is set up as stated in the users manual, a great piece of kit.
Date published: 2016-12-09
Rated 3 out of 5 by from Inlet pipe too short! I bought this unit to replace a failing more expensive one. The specs look good and the price good. Unfortunately when I cam to fit it, the inlet pipe and to some extent the outlet pipe are too short. I am using Hep2O push fittings, but it is likely to be an issue with other push fittings and even compression connectors might struggle. Once on, the fittings are almost impossible to remove as there is not enough gap between the case and the end of the fitting. The inlet pipe also has an extra screw attaching it to the unit body and this reduces the available pipe. The result is an incomplete seal and a rather large fountain! Not impressed.
Date published: 2016-11-12
Rated 5 out of 5 by from Gret bit of kit This has replaced a lower cost item which only worked for 4 months before fizzing and stopping!! The Galaxy was simple to fit and is performing well. Can deliver really hot water at low flow rate and water at great hand-wash temperature at a reasonable flow.
Date published: 2016-02-13
Rated 4 out of 5 by from Best water heater. This is good water heater esy to fit quick hot water .
Date published: 2015-12-29
  • y_2017, m_3, d_20, h_14
  • bvseo_bulk, prod_bvrr, vn_bulk_1.0.0
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_13
  • loc_en_GB, sid_93177, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix

Can this be wired into a 13 amp fused spur ?.

Asked by: icecreamandjelly
No. The answer is definitely no, this would be extremely dangerous. The Powerstream product will need a dedicated power supply feed to the maximum rating of the product (9.5kW) with the appropriate cable size and fuse protection to meet the conditions of the installation. If you are unsure please seek guidance of a qualified electrician.
Answered by: Steve - Galaxy Expert
Date published: 2017-03-12

Will this Galaxy GAP95 Powerstream unit supply hot water to a sink with a monobloc mixer tap?

The sink is in a bathroom. I've been told that the Redring Powerstream ECO unit does not work with Monobloc mixer taps.
Asked by: EnthusiasticandHandy
No, the Powerstream units will not work with a monobloc tap. The Powerstream units are designed to supply warm water to spray taps only.
Answered by: Steve - Galaxy Expert
Date published: 2017-02-07

Will this water heat be ok supplying hot water to a thermostatic mixer tap?

Asked by: CTCTCT

Remote Fitting. I need to supply a basin in the kitchen & a basin in the bathroom. one basin is 3m & other is 7m away from where I am thinking of putting it. Will this product be suitable?

Asked by: Rickster88
We would not recommend the Powerstream product for a kitchen application where a high flow rate and a hot water temperature are required. The Powerstream is designed to produce hot water for hand washing and showering applications where a flow rate of between 4 and 6 litres per minute is required.
Answered by: Steve - Galaxy Expert
Date published: 2017-02-17

where abouts is power connected to the unit, left or right as if in horizontal position?

Asked by: texasgold
  • y_2017, m_3, d_20, h_19CST
  • bvseo_bulk, prod_bvqa, vn_bulk_1.0.0
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_10
  • loc_en_GB, sid_93177, prod, sort_[SortEntry(order=LOCALE, direction=DESCENDING), SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
Specification
Brand Galaxy
Manufacturer Guarantee 3 Year Manufacturer's Guarantee (T&Cs Apply)
Manufacturing Standards BEAB
Model Name Powerstream
Pack Size 1
Pieces in Pack/Case 1
Power Output (Watts/Kw) 9.5 kW
Power Voltage Supply 240 V
Product Depth 74 mm
Product Height 160 mm
Product Type Unvented Instant Water Heater
Product Width 307 mm
Total Product Weight 2.04 kg
Water Heater Application Universal Water Heaters
Water Heater Location Undersink or Oversink Water Heaters
Water Heater Product Type Electric Water Heaters

W x D x H: 307 x 74 x 160mm. 9.5kW energy consumption. Control location: . 240V. . . . Weight: 2.04kg. Fitting size 15mm. BEAB.