Rated 4 out of 5Â by Tilertom Good value cutters
I didn't find a problem with different sized countersinks and plugs, and at this price I don't expect them to perform well indefinitely but fine for occasional use.
18 May 2016
Rated 5 out of 5Â by jack99 Does what its supposed to
I wanted some counter sinks for laying some decking and they did the job well. The the best in wuality but thats not expected with the proce paid. Worth buyin for a diy woodworker.
29 Apr 2016
Rated 4 out of 5Â by warpc0il Mixed results?
I'd only been using the larger set, until today, and getting very good results. The plugs were smooth and tight.
However, this morning I used the smaller set and the plug cutter was chattering, even in the pillar drill, and the plugs were rough and undersize.
Inspecting the small cutter I found a burr on the inside from where the cutting edge had been ground. I removed this with a needle file (could have used a rolled tube of emery paper) and tried again.
This time the small plugs were also smooth and tight.
This may well explain the very mixed results reported by some users.
Another quick tip: If you want to sink an existing screw then remove the pilot drill from the countersink and reverse it, so the tail of the drill acts as a guide and doesn't chew the screw hole. If it's a bit loose then wind tape around until it's a snug fit in the hole. Great for hiding screws on garden furniture etc.
21 Apr 2016
Rated 3 out of 5Â by Verified Reviewer Ok for price
Good price. Cutters and countersink are accurate size for each other. Some reviews say differently. I suspect drill was not held securely enough when using. Have used them in solid oak counter tops. Use at slow speed and you should find they work well. The drill bit snapped after about 10 holes, but I simply put a better quality wood bit in and it works well. Perhaps consider a better drill bit for the countersink from the start. Useful to have and the end result is very pleasing. Would buy again for the plug cutters alone.
20 Jan 2016