Rated 4 out of
Nearly But Not Quite
These fittings were well priced and arrived quickly direct from the supplier, they were packed in sets of ten which at first I thought would be a faff but turned out quite useful as on the ladder fixing the panels it was easy to get at the fixings in a matched set in my pocket. The spacers work well with just enough give and the caps are quite flexible and seal we'll. The only down side are the screws, they are much too soft, I couldn't use an electric driver even very slowly as it chewed the heads, I ended up throwing the supplied screws and using goldscrews (4x50) which worked a treat and went in with the driver. It would have been 5 stars across the board but for the screws, remember to order these at the same time.
Date published: 2016-09-26
Rated 5 out of
Fantastic value for money for these screws with spacers which are necessary, and things that you need usually cost more.
Date published: 2016-09-15
Rated 4 out of
everything about this product is exactly as described except screws. they're low quality and no matter which bit you use they keep flattening. had to buy separate screws to use with spacers and head covers, which are excellent
Date published: 2016-07-23
Rated 5 out of
Very fast delivery,
Excellent product the spacer that goes under the sheet stop you from over tightening and compressing the roofing sheet and helps to make a better water proof seal with the screw and cap.
I well recommend this product.
Date published: 2016-07-10
What driver bit do I need for the fixings
Hi there and thank you for your question. We recommend you drill sheets singly with a masonry bit, using a low speed drill and light pressure. Make sure to support the sheet securely under each hole position when drilling. Holes for fixings should be drilled larger than fixing to allow for expansion, typically 10mm for a 3 m sheet. Avoid drilling and cutting sheets in cold weather. Warm sheets will be less prone to damage.
Date published: 2016-08-20
What diameter drill bit is required to fit the Vistalux Corrugated ASB PVC Sheet Fixings Clear x mm Pack of 200
Good morning. Thank you for your question. You need to use a 10mm masonry drill bit. All installation instructions can be found by downloading the Vistalux Fixing Guide which can be found under the Products tab on our website. Thank you.
Date published: 2016-07-11
How long are the screws in this pack
They are to be used for another corrugated sheet
Good afternoon Mr Jewkes. Thank you for your question. The screws measure 50mm. Please note that they are only designed to be used with our 3" ASB profile corrugated PVC sheets. Kind regards from Ariel Plastics Support.
Date published: 2017-01-27
||10 Year Manufacturer's Guarantee (T&Cs Apply)
|Pieces in Pack/Case
||Corrugated ASB PVC Sheet Fixings
|Total Product Weight
W x L x Th: x x . Weight 2kg.
*Delivered direct from our suppliers in the number of working days stated on the delivery button