I have just swapped to my raker. But on inspection it seems that it is not parallel (to the ground) It seems on the 'skew'.
I have refitted it but it is still the same.
Anyone else had this problem or is the normal?
The instruction manual reads:
1). Remove the grass catcher .
2). Place the product upside down on a flat stable ground to
have access to the underbody.
3). Loosen the two bolts (22a) with a suitable wrench,
remove them together with the spring washers (22b) and
the presently attached cutting device (21 or 23). (See Fig.
4). To remove the cutting device, first lift the bearing and
then pull it out from the drive shaft (25).
5). Align and insert the respective cutting device: Slide
the hex nut into the socket of driving shaft (25) and fix
the bearing to the support with the bolts (22a) and spring
washers (22b). (See Fig. 12b).
If the instructions have been followed correctly then the attachments should be aligned correcly. If this is not the case then there may be a fault with the product. If this is the case, the product is within warranty and the order/invoice number can be provided, then we would be able to offer an exchange. This can be done via our customer services team on 03330 112 112 or by heading into your local Screwfix Trade counter. (The product would need to be cleaned 'within reason')
Thank you for using Q&A.
Date published: 2017-03-12