Rated 1 out of 5Â by Richard9 Waste of money
Went into the store to buy a replacement immersion heater and realised I would need a spanner so bought this. Unlike other reviewers it did fit the immersion heater hex but that's all that can be said of it. Edges are sharp where it's been stamped out of a flat sheet of steel so had to wrap a towel around the 'handle' so I didn't cut my hands. Old immersion had been put in with Boss White and rather than undoing it, all this did was bend.
15 Oct 2016
Rated 4 out of 5Â by Pierre Strong Tool
Made short work of replacing immersion heater element. However, it did need dressing with a file to make it fit the element hexagon. Should last a lifetime though.
5 Jul 2016
Rated 1 out of 5Â by Y3BRC Poorly made
Had to file down the inside of the spanner as there was rough edges which meant it wouldnt fit properly.
14 Jun 2016
Rated 3 out of 5Â by Curryoverdose Disappointing.
Was too tight to fit on the element. It wasn't the element it was definitely the spanner. Had to spend half an hour filing it out.
Disappointing considering the brand.
1 Oct 2015