Browse store

Labgear Professional Splitter 6-Way (48074)

Passive wide band splitter, power pass to 1 port. Fully shielded in die-cast module. F-connectors throughout.

More Info

Bulk Save Save up to 5%
QTY Price per item Saving
1 - 4 £8.18 -
5 + £7.77 Save 5%
£8.18INC VAT

Add to basket for...

Labgear Professional Splitter 6-Way is rated 5.0 out of 5 by 13.
  • y_2017, m_7, d_16, h_22
  • bvseo_bulk, prod_bvrr, vn_bulk_1.0.0-hotfix-1
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_13
  • loc_en_GB, sid_48074, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix

Add to saved list...

Save
Rated 5 out of 5 by from Works well even with 1 unused Great item works well, This replaced my mains powered amplified splitter. NOTE: I used this to split one antenna into 5 runs of cable around my house, for the last unused port (DC through) i added a F Male 75 ohm terminator, which closes off the open port. Open ports can cause signal reflections and unwanted interference. This can result in poor signal quality leading to poor pictures. Overall very happy.
Date published: 2017-04-10
Rated 5 out of 5 by from Perfect for the job Good bit of kit. Works very well. Does what it is supposed to do. Would buy again.
Date published: 2016-07-28
Rated 5 out of 5 by from Just what I neds Ideal bit of kit works just the way it describes and small enough to not be noticed
Date published: 2016-05-03
Rated 5 out of 5 by from Exceptional Upgraded from the 4 way to this 6 way one as I wanted to add a few more tv points in the house, works a treat.
Date published: 2016-05-02
  • y_2017, m_7, d_16, h_22
  • bvseo_bulk, prod_bvrr, vn_bulk_1.0.0-hotfix-1
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_13
  • loc_en_GB, sid_48074, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix

Can I use this to run 6 tv's off,with my roof aerial connected to the input?

Asked by: Tedbucket
Hi, basically yes, however the signal received on the TV's will be dependant on how strong your TV signal reception is as you are just splitting the signal and not amplifying the original signal. If you need any further assistance please contact our technical helpline on 08457 573479. Thanks
Answered by: Philex Electronic
Date published: 2017-06-26

My televisions in the bedrooms through a Labgear 6 way splitter have stopped working. Is there a battery inside which may need replacing?

Asked by: Ianp5
The aerial circuit requires further investigation, it would be a good idea to take a direct feed from the aerial to a TV to see if there is a good signal being received at the input of the splitter as it is unlikely the splitter would just fail. Any problems please call the Labgear technical helpline so we can assist further. Thanks
Answered by: Philex Electronic
Date published: 2017-02-25

Does the Power flow both directions?

I plan to use this to split signal & power from behind sky box to run two magic eyes from it. i have just bought the 4 way one, however, power only runs from all the outs to one IN, meaning that I cannot power two coax cables from it to each magic eye.
Asked by: chuffy100
Hi, based on the information you have given us the 2 way splitter should do the job with less downgrade in signal quality - part no.99105. Thanks
Answered by: Philex Electronic
Date published: 2016-08-13

Does this splitter need a power source & does it go into the loft ?

Asked by: Kirky123
The splitter does not require a power supply feed and can be placed in the Loft as it is best to split the signal as near to the Aerial as possible. Thanks Labgear UK
Answered by: Philex Electronic
Date published: 2017-01-27

How do I join cable to the f-plug?

I have bought this splitter and a set of 10 connectors but they connect to the splitter (screw on) and have a coax female other end. I can only find female crimp-on connections for my cable and either need male or a splitter with f type socket instead of plug. How do I join if I can't locate any of these?
Asked by: KateB
Hi if you use Screwfix sku 17061 on the cable this will then connect to your splitter. Hope this helps. Thanks
Answered by: Philex Electronic
Date published: 2017-01-27
  • y_2017, m_7, d_19, h_4CST
  • bvseo_bulk, prod_bvqa, vn_bulk_1.0.0-hotfix-1
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_6
  • loc_en_GB, sid_48074, prod, sort_[SortEntry(order=LOCALE, direction=DESCENDING), SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
Specification
Brand Labgear
Manufacturer Guarantee 1 Year Guarantee
Pack Size 1
Pieces in Pack/Case 1
Total Product Weight 0.144 kg

Power pass to 1 port.