Forge Steel Sash Clamp 24"
Not to bad, ok in fact.
I bought 4 of the 24 inch clamps. I was running out of clamps when making several oak kitchen doors.
Firstly the bad points. The jaws do not stay square especially the movable jaw. The location pin drops out. But I have this in more expensive ones. The tommy bar is short and of a small diameter.
On the plus side. They are solid and rigid in use.
The screw thread runs freely. Quick to adjust and the location pin is attached to the clamp by a wire. So when it falls out, which it will, no searching on your knees. For the price I have seen far worse.
7 May 2015
Does the job
I needed a clamp to press 2 boards together to glue, and this did the job well.
19 Mar 2015
excellent. I already have the 1200mm size of this make and needed smaller size for current project.
12 Feb 2015
Should not expect too much for the money but this product is poorly finished. The heads are very uneven and pieces of wood used as protection tend to slide out because of unevenness. The retaining toggle falls out at the slightest angle. You have to be careful on tightening the clamp: the loose fit of the moving head causes it to move from alignment. With these points in mind, the clamp will do its job but if I had borrowed one prior to buying, I would not have purchased.
17 Dec 2014