1Â¼" Bottle Trap Chrome-Plated Brass
leaks at main seal
FAirly good metal materials, but poor rubber seals. the flat washer between the basin waste and top flange of the trap is so thin it mis-aligns and pushes up into the basin waste when you tighten. I cut a new washer from a piece of 3mm rubber sheet and solved this. So conclude the design is flawed as it doesnt fit all basin wastes. needs a thicker washer to be supplied in the kit
Also the seal on the side pipe is another very thin rubber seal which has to be tightened to the limit to make a good seal.
i'm not buying any more of these.
1 Jul 2014
Great value good looks
Looks like a much more expensive trap. Easy to fit and looks perfect. Just the job for a small cloakroom basin.
19 Jun 2014
Tricky, but worth the effort
It looks really nice on, but it takes a while to get it all straight, lined up and sealed.
I had to dismantle it a few times and make sure the length of the vertical tube was just right to get the horizontal tube in square with it. Trial and error really, but until it is just right the rubber seals leak slightly.
Would recommend, but don't try to rush the installation.
28 May 2014
Don't waste your money
Looks nice, but fails on multiple fronts. The outlet pipe is 28mm and expands up to almost 32mm, but this means you can't use standard 32mm chrome pipe to extend to the wall. The flange on the up pipe that connects to the waste is too narrow so the rubber washer keeps slipping inside the fitting. None of the parts seal at all well and you'll find yourself wasting lots of time undoing and then re tightening the fittings only to find another seal is leaking.
7 Apr 2014