Terminal screws for com, L1&2 seem too short
Brass screws in the 1way switches screw all the way down through the terminal hole. However on the 2Way and Intermediate switches. The brass screws barely screw down at all. Max about 1mm is visible in terminal hole.
Why?
Asked by: DGGrim
Problems solved. Seen many posts about the screws being very hard to loosen and it’s the same for tightening. You almost feel like you’re going to break it but they do tighten all the way.
Answered by: DGGrim
Date published: 2021-02-09
Is this suitable for a 2 way switch?
I’ve got lights in my hallway with two switches (one at either end) so the switch needs to turn on and off in both directions.
Is this switch a suitable replacement?
Asked by: AnotherReviewer1
Yes.
The question has been asked previously and that's what my answer is based on. (Page 2 of the questions, I think it's the first question asked)
Answered by: r8sso
Date published: 2021-01-16