January Clearance - Now On!

Aurora 1.2m LED Cuttable Striplight 5.8W 360lm (9486V)

£ 15.99INC VAT

Add to basket for...

Aurora 1.2m LED Cuttable Striplight 5.8W 360lm (9486V)

Single colour flexible LED strip with self-adhesive backing (must be applied to clean surfaces). Ideal for fast installation applications such as under cabinets, televisions and decorative shelving. With a beam angle of 120° and 16mm between LEDs, individual light points are less visible creating a continuous glow. Cut points every 50mm for maximum flexibility of length. Comes with 1.5m flex (to connect to the driver) and 0.3m tail attached (in case multiple strips need to be connected). 12V DC constant voltage LED driver required.

  • IP20: For Indoor Use
  • Warm White
  • 360lm
  • 60 Lights per Metre
  • Can be Cut to Size By Installer
  • Up to 35,000 Hours Life
  • Compact Design
Energy Rating F

Product Information Sheet

More Info

View all: Aurora LED Strip Lights

£15.99INC VAT

Add to basket for...

Add to saved list...

Rated 5 out of 5 by from Good Product Along with the Aurora LED Driver this make a good undercabinet light.
Date published: 2020-10-09
Rated 5 out of 5 by from LED STRIPLIGHT I have installed this product quite a few times now and very happy with it good quality and easy to install.
Date published: 2019-05-19
Rated 4 out of 5 by from Great LED Tape lights I installed two of these lights for a customer with the transformers. Very easy to install and a happy customer.
Date published: 2019-03-03
Rated 5 out of 5 by from What you need to know These tape borne LED lights are very bright and versatile especially if you are handy with a soldering iron. The tape is 8mm wide and at each side of the line where you are told you can cut them there is a pair of bare copper plated pads connected to the supply lines. The pads are about 2mm in diameter so you can cut the tape and, with a small tip soldering iron, reconnect the pads together using pieces of the supplied wire to go round any type of corner. So no fancy connectors needed to join round a corner and awkward angled corners aren’t a problem. If you don’t fancy soldering then the strips all have wires pre-connected at each end so you can cut a strip and you immediately have two already wired strips or you can use the wires to connect to another strip. As for the adhesive, well so far they have stayed on. I cleaned the surface with spirit (meths) and then peeled the protective strip off as I stuck them down. Trying them in place and then moving them using the self-stick would be asking for trouble. The resulting effect is brilliant. No clips or wires visible and the profile of the strip is only around 1mm so you don’t even need a pelmet if you don’t want one. Just setting the tape 25mm back from the edge of the cabinets should do it. The Aurora 12V driver works perfectly with these LED tape lights.
Date published: 2018-12-16
  • y_2022, m_1, d_27, h_20
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.20
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_7
  • loc_en_GB, sid_9486V, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getReviews, 11ms

Hi, is this strip light really energy rating F. Confused as I thought they were energy efficient.

Asked by: DIYDorothy
Hello, yes this is correct. Due to the new ERP regulations, whcih is an industry wide change. It is important to understand that the product has not been donwgraded and the spec has not changed but the calculations concerning energy rating have been updated. We’ve also been doing multiple campaigns on social media to reach contractors and end users, it may take time to understand the new regulations but almost all lighting products will now have a classification of D and below. I hope this helps.
Answered by: Aurora Technical
Date published: 2021-12-08

The spec states that these lights are dimmable. To make them dimmable what is the correct driver to use.

Asked by: Backman
Hi There, This is 12v strip, depending how many meters you intend to use will depend on the driver you use. Please search for a 12v dimmable LED driver in the correct wattage required. Thanks Aurora
Answered by: Aurora Technical
Date published: 2021-11-29

Can these be hardwired to the house lighting ring

if I want to wire these into the houses lighting to work off a light switch can this be done? and what is required?
Asked by: MarkS13
Hello, thank you for your email. You will need an LED driver to power the length of strip, you can use an AU-LED1012CV then you will need to wire this to an on/off roker switch to control.
Answered by: Aurora Technical
Date published: 2021-06-21


Hi Guys, I know these strip lights come with a sticky surface, but can they be pinned at regular intervals with something like drawing pins onto the underside of work surfaces? Thanks Mark
Asked by: Anonymous
Hi There, No nothing go penetrate the strip and it will break connection and fail. You can purchase 'Strip fixing clips' Search this term in google. Thanks Aurora
Answered by: Aurora Technical
Date published: 2021-02-06

Lumens per....?

Brightness is listed as 360 lm (lumen) is that per metre or per foot? All the different lengths of Enlite LED strip are listed as 360 lm, so difficult to work out.... Please advise thanks
Asked by: SteveW123
Hopefully Screwfix CS has answered your question. Many thanks Aurora
Answered by: Aurora Technical
Date published: 2020-05-01
  • y_2022, m_1, d_27, h_20CST
  • bvseo_bulk, prod_bvqa, vn_bulk_3.0.20
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_12
  • loc_en_GB, sid_9486V, prod, sort_[SortEntry(order=LOCALE, direction=DESCENDING), SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • CLOUD, getReviews, 11ms
  • bvseo-msg: BV SEO Content for this product did not include verbose reviews.;
Brand Aurora
CALC - Light Bulb Technology LED
Colour Temperature Description Warm White
Colour Temperature Value 3200 K
Dimmable Dimmable
Domestic/Commercial Use Suitable for Domestic & Commercial Use
Energy Rating F
Fixings Supplied Fixings Not Required
Indoor/Outdoor Usage Indoor
IP Rating IP20
kWh Per 1000hr Life 5.8 kWh/1000h
Life Length 35,000 hours
Light Bulb(s) Supplied Integrated LED
Light Bulb Technology LED
Lm 360 lm
Lm Band 201-400
Manufacturer Guarantee 1 Year Guarantee
Model No EN-STK1200
Pack Size 1
Pieces in Pack/Case 1
Power Consumption 5.8 W
Power Type 12V Power Supply
Power Voltage Supply 12 V
Product Type Cuttable Striplight
Smart Compatibility Not Smart
Tape Length 1.2 m
Tape Width 8 mm
Transformer 12V LED Driver Required


Instruction Manual