Rated 5 out of 5Â by ITGuy82 ....a hot knife through butter
I am currently building an office work bench using Trespa. As everyone knows, Trespa is hard as boots.
After trying various other cheaper brands which struggled, I finally tried a "Trend 2-Flute Straight Cutter Â¼" Shank 6.3 x 16mm"
This just cuts through the Trespa like a hot knife through butter. You do have to take your time and go slow but the finished edge is smooth, straight and clean with minimal finishing required.
11 Sep 2014
Rated 5 out of 5Â by Dabbler50 Trend 6.3mm router cutter
Does what it says and does it well. Been using this building walnut veneer mdf furniture and it has performed flawlessly, clean cut every time on a router table.
3 Jul 2014
Rated 1 out of 5Â by chippythe1st trend 2 flute cutter
Cutter is advertised as suitable for plunge cutting. The item I received, which after some investigation was the same as that being sold elsewhwere, did not have the bottom cutting edges covering the whole surface. The result of which being dimples on plunge cut in the bottom of the groove not very desireable in sign work for which it was purchased.
2 May 2013