Rated 5 out of 5Â by SPOTTHEDIFFERENCE Tower Plastic Inspecion Bend.
Does what it's made for, a thin gasket on inside of lid would be a bonus. Dependant on size of cables being used can be tight threading cables through but that applies to all inspection bends.
30 Nov 2015
Rated 4 out of 5Â by ScotinSomerset Useful for certain application
Neat and secure solution to making a 90 degree bend in rigid conduit, but watch what you route through it - 2 x 2.5mm T&E cables will go through it, but only with care, to avoid damaging the insulation on the sharp internal edges. Still worth it for a neat finish, though. Single 2.5mm, or twin 1.5mm T&E thread through much better.
7 Oct 2015
Rated 4 out of 5Â by moltensteel Just a little caution...
The moulding has quite sharp internal edges so when feeding cable through you can actually strip the insulation if you try pulling too hard and fast.
Otherwise good value.
11 Nov 2013
Rated 5 out of 5Â by 129ASwanseaInWales TOWER INSPECTION BENDS 30mm BL
HAD THESE FOR A SMALL JOB NO PROBLEM FITTING THEM AND USE THE SPECIAL GLUE TO SEAL THE JOINTS FROM ANY WATER GETING IN AND TO LOCK IT TIGHT,FOR A GOOD JOB DONE.
8 Sep 2011