Rated 1 out of 5Â by stubrum poor blade
i bought this for a large bathroom job that was using fairly soft ceramic tiles, the previous Erbauer disc had run its course so opted for this more expensive one! this blade not only chipped the tiles to death but also cracked the tiles when cutting width-ways!! i personally wouldn't bother.
Rated 4 out of 5Â by blonuck marcrist diamond disc cutter
4.5 would buy this item again if required to. Did the job great ( cutting porcelain tiles ) with no chip outs
Rated 5 out of 5Â by Jools75 Good product
Despite the other review we've found this to be a good disc. Bought it when we bought the tile cutter as it's thinner than the factory supplied on. Been cutting marble with it and it leaves nice clean edges - yes it's slow going, but cutting any kind of natural stone is hard - we did have professional tilers onsite using an angle grinder cutting the same tiles and the cut they made was quicker - but a load more dust and too many chips - going slowly with water and the edges we get using this disc with a wet cutter we get far better results - does mitre cuts great too
Rated 1 out of 5Â by DrDeAtH Rubbish
Cuts fast... That's all
It chips the tiles to death even when feeding slowly through the tile saw.
No good, don't waste your money