Marcrist CK650SF Diamond Tile Blade 115 x 22.2mm
Not sure its ultra thin
Not sure I would describe this as Ultra thin.
I borrowed a disc from a tiler for my last job so thought I'd buy my own this time. The one I borrowed was much thinner than this.
It does cut well and as you can use it dry there is far less mess.
18 May 2015
Great bit of kit
Used it to cut though angles on Tiles. Did the job easily.
Very hard wearing and good quality.
A must for awkward angles and small cuts
2 May 2015
Cut channels through 3 layers of old kitchen tiles so they could be removed from the wall far quicker than using a hammer and chisel.
Shows very little wear after use great product.
29 Jan 2015
Excellent bit of kit
After miserably failing to cut some 10mm floor tiles I decided to look for an alternative method.
I used this attached to a Makita angle grinder (not tile saw), a steady hand is needed and you have to keep the blade as bang onto 90 degrees as possible.
The blade must be cutting down toward the tile, the other way around will break the tile.
Because I was using a hand held power tool there was a small amount of chipping but as it was being butted up to a wall and sealed, this covered any tiny edge marks. I'm in no doubt that this blade would give perfect cuts in a tile saw.
10 -15 tiles later and there is no show of wear whatsoever, very impressed and very versatile cutting blade.
9 Dec 2014