Browse store

LAP Standalone PIR 180° (36316)

Polycarbonate.

  • IP44
  • 12m Detection Range
  • Adjustable Dusk-to-Dawn Sensor
  • Adjustable Time On
  • Manual Override
  • W x D x H: 65 x 120 x 65mm
  • Model No: SF-SA-180-W

More Info

£6.99INC VAT
Was £13.99 Save £7.00 (50%)

Add to basket for...

LAP Standalone PIR 180° is rated 4.1 out of 5 by 54.
  • y_2017, m_5, d_19, h_13
  • bvseo_bulk, prod_bvrr, vn_bulk_1.0.0-hotfix-1
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_54
  • loc_en_GB, sid_36316, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix

Add to saved list...

Save
Rated 5 out of 5 by from LAP PIR Just reworked the garden and removed the old floodlight/pir combo. this works so much better than the old system and i was able to locate this in the best place with the light fittings also located propertly. easy to fit and wire.
Date published: 2017-04-12
Rated 3 out of 5 by from Good but...... Nice pir bought two but couldn't get the override to stay on longer than a few seconds. Works ok with dusk setting on daylight but once it's turned to dusk the override only stays on for a short while then the light switches off.
Date published: 2017-03-26
Rated 2 out of 5 by from Iffy product or just bad luck. Currently on my 3rd REPLACEMENT OF THIS ITEM. First unit was ok for 2months, then when arriving home in day light noticed the light on, I switched it off and on a couple of times and after a few attempts it seemed to go back into working mode, BUT THEN it went into a mode of its own, we would come in at night, it would activate the light but when it went off it wouldn't come back on.... FINALLY it came on one morning whilst I was getting in the car and hey presto when it went off ... IT wouldn't come back on at all,hence a useless item. 2nd REPLACEMENT, the item was fitted, and the complete opposite, fitted in day light SWITCHED the item to come on at dusk, but the item kept coming on in day light, don't know if it actually came on at night because I was at boiling point took it off the wall and took it back to ScrewFix. 3rd item is being fitted tomorrow, I will give a review on it, good or bad. Must admit if it fails I'll be looking for another manufacturer and product. I CANNOT fault Screwfix and there replacement of the items.
Date published: 2017-01-06
Rated 3 out of 5 by from PIR Overall a good product. Easy to instal and easy to set up. My only issue was the retaining clips holding one side of the detector together....these looked a little fragile and may snap in really cold weather. Apart from that, good product.
Date published: 2016-12-19
  • y_2017, m_5, d_19, h_13
  • bvseo_bulk, prod_bvrr, vn_bulk_1.0.0-hotfix-1
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_54
  • loc_en_GB, sid_36316, prod, sort_[SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix

Switch type?

What is the internal switch in these units, is it a relay with contacts or is it some type of solid state device?
Asked by: mcgreid
Hello, This item a relay with contacts as you suggested. Thank you for using Q&A.
Answered by: WillFarrell
Date published: 2017-04-26

I need a replacement lamp for this PIR. Where can I get one?

Asked by: Charliez
Hello Charliez, This is a standalone PIR and does not contain or include a lamp. It has max switching loads of 2000W incandescent and 500W fluorescent lighting. Thanks for using Q&A, KC
Answered by: KirstieC
Date published: 2017-04-11

Can I put two of these in parallel to control one light (which will come on if either PIR detects movement)/

Asked by: WorcsDIYer
I want to do the same thing i.e. have two of these PIR units at a distance apart connected to the same lights. Did you try connecting two of these in parallel? Did it work? Do you know if the switch in the PIR is solid state or a relay?
Answered by: mcgreid
Date published: 2017-04-18

Hi can this detector be used as a dusk till dawn i.e comes on and stays on all night till morning? Thank you

Asked by: Axol36
Hello Axol36. The standalone PIR has a dusk setting on it and if set correct you could set from dusk to dawn. Thank you for using Q&A.
Answered by: yeldarb
Date published: 2016-12-06

What is the power consumption of the PIR

Asked by: PBDave
Hello PBDave. Unfortunately we do not have the information on how much power consumption this PIR will use, it all depends on your power supplier. Thank you for using Q&A.
Answered by: yeldarb
Date published: 2017-04-10
  • y_2017, m_5, d_19, h_24CST
  • bvseo_bulk, prod_bvqa, vn_bulk_1.0.0-hotfix-1
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_11
  • loc_en_GB, sid_36316, prod, sort_[SortEntry(order=LOCALE, direction=DESCENDING), SortEntry(order=FEATURED, direction=DESCENDING), SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_screwfix
Specification
Adjustable Tilt
Adjustable Tilt
Brand LAP
Colour White
Construction Material (Lighting) Plastic
Dimmable Non-Dimmable
Fixings Supplied Fixings Supplied
IP Rating IP44
Manufacturer Guarantee 1 Year Guarantee
Max. Wattage 2000 W
Model Name IQ-SA180-D-W
Model No SF-SA-180-W
Pack Size 1
Pieces in Pack/Case 1
PIR PIR
Power Output (Watts/Kw) 2000 W
Power Voltage Supply 230 V
Product Depth 120 mm
Product Height 65 mm
Product Type Standalone PIR
Product Width 65 mm
Total Product Weight 0.251 kg

230V. 50Hz. IP44. Switching capacity: 2000W incandescent and 500W fluorescent. Fixings Supplied.

Downloads

Instruction Manual