Connection to rectangular hopper
I'm installing Flodrain chanelling and wan't to connecto 68mm od inlet to Floplast rectangular hopper is there a suitable adaptor available ?
If not can you suggest any alternative.
You will need to use the end outlet to take the channel drain to 110mm pipe and then reduce the 110mm pipe to the 68mm pipe using an adaptor.
Date published: 2016-07-09
how do you fit to main drain outlet
any additional kit required
The garage pack comes with an end outlet which will give you a connection to 110mm pipe or there are three sections along the bottom of the channel which can all be cut out to again give you connections to 110mm pipe
Date published: 2017-04-19
is the depth 300m
does the channel just sit onto abed of cement
how do the sections connect
The depth of the channel is 118mm. The channel should be sat on a 50mm base of compact sand. The channel has male & female connections either side and will just slot one into the other.
Date published: 2016-08-17
can this product be cut to accommodate angles?
Need to go through about a 135* bend and nobody seems to make this product with anything but 90* turns, can it be cut to fit and then, i guess glued or siliconed at the joints? thanks
We are not aware of anyone that produces a 135° bend. The best way of achieving angles is as you suggested by cutting the lengths and joining the ends with silicone the ends together rather than glue as silicone will allow some movement.
Date published: 2016-01-17