Rated 5 out of 5Â by securityinstaller Flo Fit on end stops
I've always been a solder kind of guy, but when it comes to end stops went for compression. But these push on fittings are great and so good when you want temporarily stop then continue a job. I had a situation recently where a ball valve didn't shut off and I managed to push on one of these fittings quickly to stem the tide, what a lifesaver. Saved a lot of mess and cleaning up afterwards, not to mention explaining to the client and facing an insurance pay out. Thanks Screwfix for recommending this as a trial.
28 Jul 2014
Rated 5 out of 5Â by Royston1961 Useful bit of kit
A great and cheaper alternative to its rivals. Can't think of any reasons NOT to buy this one if it's what you're looking for!
9 Jul 2014
Rated 5 out of 5Â by Rizo save yourself some money
do yourself a favour by saving saome money and buy these instead of buying the more expensive ones such as the JG. These do the same work as the expensive ones do.
9 May 2014
Rated 4 out of 5Â by Etihsbog Quick and easy
After reading some of the other reviews I was going to go for the more expensive JG speed fittings but budget dictated other wise. As long as the cut is good and pipe pushed home as the instructions dictate then no there is no problems with the seal. Used on both hot & cold water.
17 Sep 2013