Rated 1 out of 5Â by speeddevil68 Waste of money
This flux is too thick and when sodlering it does not flux the solder very well. I have now gone back to using powerflow and joints are perfect. This was a HUGE waste of money and time. Avoid and use Powerflow instead!
29 Sep 2015
Rated 3 out of 5Â by Mule Flux
Very thick and not the easiest to apply, I only did I couple of joints before I got bored of it, overall it's ok but not brilliant in my opinion, I use La-co instead which I find much better, I wouldn't buy this again...
3 May 2014
Rated 4 out of 5Â by aviator99 no green rust though!
Yes its thick, much thicker than La-Co but its the only one I've used which is heat activated, which means that if you get some on copper or don't wipe the joint it don't cause ver-de-gris, most of the rest will eventually cause pipe rot unless you clean thoroughly.
25 Feb 2013
Rated 2 out of 5Â by craigb dont bother
dont bother. buy powerflow or la co flux, this stuff takes longer to brush on as its very thick.
14 Nov 2010