Rated 5 out of 5Â by Mvkpe Does what it says
Bought as a replacement blade for a general purpose circular saw, used on steel pipes, floorboards, plastic soffits and lots more. Used extensively for over two years on a single blade, can't rate this blade enough.
20 Jun 2015
Rated 3 out of 5Â by robychops would not use again on metal
Had some tin roofing to cut which was only about 1.5mm thick. I was thinking of cutting this with angle grinder and metal cutting blade, but having bought the saw with a rage blade fitted and claiming it could cut up to 6mm steel i didn't think it would cause much wear to the blade unfortunately after cutting 1 sheet the blade seemed to be going blunt. Several teeth were damaged. Would possibly be alright for the odd hidden nail but wouldn't recommend for cutting metal.
15 Jun 2015
Rated 4 out of 5Â by JaneSore Like a knife through butter...
This blade takes some beating. It cuts through anything - like nails buried in wood. It leaves a perfectly smooth edge on plastic pipe. It slices aluminium sheet and steel - such as threaded 10mm bar.
Gone are the days where you worried about snagging and the menace of teeth flying off at high speed.
Just make sure it's running at top speed and go for it.
18 Apr 2015
Rated 4 out of 5Â by DIYadict Good blade
does the job, cuts anything and lasts well.
Doesn't burr wood even after cutting steel
6 Apr 2015