Erbauer Quick-Release Magnetic Bit Holder 65m x Â¼" Hex Shank
Mag bit holder
The whole point of a magnetic bit holder is to hold screws so they don't drop on floor when trying to drive them in. The magnet on this bit holder is not even strong enough to hold the smallest of screws. Also the quick release is almost impossibly stiff.
18 Dec 2014
A little better than useless
Does the job, but not very well
No magnetic force at all so screws drop off , no need for the quick release as all this does is get in the way when going at an angle
8 Nov 2014
Not Magnetic and Wide End
Locks the bit in well but almost no magnetic force at all. Will not pick up the smallest of screws or hold it on the end. Also, something I didn't think about before ordering, is that the wide end gets in the way when putting a screw in diagonally, or more than a cm below the surface. For example when wanting to peg the screws with dowel later. If you're only sinking screws to flush on a flat surface it will work but then you'll still want the magnet to pick up the screws and hold them on the bit, so not a lot of good really.
20 Oct 2014
For the money it cost I must admit not expecting a lot from this but was very impressed by it. Fairly good magnet and quality has not been compromised by its price. Good job all round.
5 Oct 2014