0500 41 41 41
Cookie Reports - Screwfix Cookie Policy

Unbranded

Diamond Tile Drill 12 x 85mm

Product Code: 86173

Rated 3.3 out of 5 by 3 reviewers.

Good quality, long lasting tile drill for wet cutting of marble and tiles. Longer drilling life with faster, free machining action.

View more information

£2.49 (inc. 20% VAT)

£2.49
3.3333 5 3

Add for Delivery

Add to saved list


Not available for deliveryOut of Stock for Delivery
Available for collection from store Store Collection Check stock in your store
Page 1 of 2
Rated 4 out of 5 by Cut thick porcelain tiles This cutter did a fine job making easy work through some thick porcelain tiles to allow me to then drill the block behind with a 12 mm bit to fit some rigifix plugs. It did not need water, i just kept the speed low and it took no time. To avoid these skimming all over the tile, Note that these are too small for a pilot, the trick to getting them to bite on target is to approach the material at an angle of say 45 degrees, then once through the glaze straighten up the drill and keep going.. 18-Dec-2013
Rated 5 out of 5 by diamond core bit bit cut through porsalin tiles no problem, used with water to keep bit cool 19-Jun-2011
Rated 1 out of 5 by Warning Not sure if I managed to keep the core drill cool enough as I managed to drill two hole in the floor tiles with no problem. I then tried to drill two holes in wall tiles, the first of which went fine but on the second the drill stopped working as it lost its cutting edge. This could have been my fault for not getting enough water on to the work area but always difficult on walls. 21-Apr-2010
1-3 of 3

Specification

Pack Size 1
Product Diameter 12 mm
Product Length 85 mm
Shank Size 6 mm
Total Product Weight 0.032 kg