Rated 4 out of 5Â by Sesa35 Great Blades
Good fine cut for joinery, cuts with out pressure,good dewalt product.reasonable value.
Rated 4 out of 5Â by geebee Good wood cut
(DeWalt 190x30mm 40T TCT Circular Saw Blade
Product Code: 37496)
Purchased for cutting melamine faced chipboard. The cut is nice and clean but it still (as expected) chips the melamine slightly.
The chip sizes were generally below 1mm size. Possibly also influenced by the quality of the melamine.
It also does a very clean cut on plywood with just a little sanding on a cross cut to tidy up the edge on the trailing face.
I didn't do any pre-scoring.
If you want (near) perfection then I'd suggest going for an 80T blade. I just couldn't justify the Â£80 or so for the job I was doing.
(I only gave 3 stars for reliability as I've only used it for 30meters of cutting so far. Therefore, I can't comment on long term reliability)
Rated 1 out of 5Â by sirfloodalot very poor
I do not rate products normally , but this one avoid this one , I have brought a new bosch circular saw , put this blade in , have cut down to internal doors , and now the blade is struggling , what a waste of money
Rated 5 out of 5Â by captainginge good quality
Good fine cut for joinery, cuts with out pressure,good dewalt product.very good value for moderate cost.