Cuprofit Pushfit Release Tool
Maybe it is me (I am DIYer after all!), but I couldn't get this to do the job. The stop ends themselves went on fine, but this was flimsy, didn't seem to grip properly, and (worst of all# you need a bit of room to fit it to the stop end. So if you have something like a compression joint close to the stop end, getting this to fit on can be difficult to say the least. Eventually I used a screwdriver and brute force #not ideal I know). I have now binned the stop ends becasue of this.
9 Mar 2015
Man mountain Garth
This product is a good one but there are no instructions with it and while it did the job, after a fashion, you needed to be "Man Mountain Garth, to get the pipe out of the joint.
Would like to see instructions etc . Still don't know what the two grey rings are for??????
5 Nov 2014
pushfit release tool
The Pushfit release tool is a godsend. It has a very simple design but is so efficient. . No need for instructions it is so easy to use."
16 Jun 2014
Simple but effective tool
I was using conex fittings so I thought I might as well add a release tool to my kit. When I got my first tool I couldn't figure out how the 22mm worked. After looking closely I discovered the insert was marked 18 and sure enough when I measured it that was correct. I took it back and Screwfix quickly sorted it out and got me a replacement. This time it had the right insert and worked a treat. Not much to it but it does the job.
1 Apr 2014