0500 41 41 41
Cookie Reports - Screwfix Cookie Policy


Confirmat Screws M7 x 50mm Pack of 100

Product Code: 36633

Rated 5 out of 5 by 5 reviewers.

Coarse thread. For use in lightweight carcass assembly where a right angled joint is required.

View more information

From £4.49 (inc. 20% VAT)

5.0 5 5

Bulk savings

No. of packs 1 - 9 10 +
Price per
£4.99 £4.49

Add to saved list

Available for deliveryNext Day Delivery
Available for collection from store Store Collection Check stock in your store
Page 1 of 4
Page 1 of 4
Rated 5 out of 5 by Good for MDF Agree with other reviews. You need to drill straight, drill a clearance hole at 6.5 - 7mm through the board, then pilot the MDF edge with 5 - 5.5mm hole and the and drill a bit deeper so the screw can't bottom out. and countersink a bit. Then it holds brilliantly and really this is the only screw that doesn't routinely split the MDF. 10 Jul 2014
Rated 5 out of 5 by Top fixings I made a full set of Kitchen cabinets with 18mm MDF and these. Huge holding power and if they need to be visible, they gives a neat, professional looking finish. I found a 7mm countersunk clearance hole and a 5.5mm pilot hole worked best. 22 Jun 2014
Rated 5 out of 5 by Superb Used these to create MDF loft boxes out of 12mm MDF (to save weight and cost). Yep, That's a 7mm screw into the end 'grain' of 12mm MDF without splitting. I used a 5.5mm hole a little deeper than the full length of the screw. Lining up the drill to make sure I didn't pierce through the side of the MDF was a precise job though! 4 Nov 2013
Rated 5 out of 5 by Strong Recently used these to build a MDF cabinet. They require a 6mm pilot hole covering length of screw. They work great and make strong fixings. I found the MDF-Tite screws (70134) split the material when screwing in end on. 11 Dec 2012
Page : 2 next>


Bolt Size M7
Pack Size 100
Product Diameter 7.5 mm
Product Length 50 mm
Product Type Confirmat Screws