Conex Push-Fit 090 90Â° Elbow 15mm
Pushing up my Skills
Always used traditional compression fitting until now. These make it so easy I am thinking I should start another project off just to keep using them.
Very good in difficult areas. Brilliant
5 Nov 2014
use an alternative
Bought this to use in a narrow area (for a shower job) , thought that a normal fitting would have been too bulky as had to sit in a recess.
Got two of these fittings to be used from PE-X to copper pipe.
One of the joints just leaked and spat, no matter what.
I have used Cuprofit connections in the past and these had worked fine and only reason not used this time was due to using the PE-X pipe. These fittings could just not be relied upon so changed to compression fittings instead in the end.
on another downside note, once you have pushed in the pipe to these fittings, you won't be able to get it out easily again , unless you use the correct tool (I was not hoping to have to take the fittings off as did not expect them to leak so think about that before hand also because you would need to shell out more money)
use an alternative is my advice.
31 May 2013
I couldn`t put a pipe in a snowmans mouth before but after using these push fit`s i`ll gladly tackle any plumbing around the house. only reason it never got 5 stars on reliability is because it hasn`t been installed for very long.
26 Apr 2013
Used this push fit connection in good faith. All seemed to be well until the water was turned on, it was then I found outthat one of the seals was deffective and water sprayed everywhere. Replaced it with a soldered joint.
13 Jan 2013