Rated 5 out of 5Â by Herby01 Backnut
Purchased these to swap over from the plastic nuts that came with the taps and have since broke. Should of swapped them to these from the off and saved the hassle. Good quality item and a fraction of the price that a similar diy store sells a single item for
22 Jun 2016
Rated 5 out of 5Â by Jay2016 Does the Job
Does the Job. Seems good quality. only time will tell how it holds up but so far so good
6 Jun 2016
Rated 5 out of 5Â by Surfer2 Quality Brass Backnut
I recommend this brass backnut to stop tap spin. Insert tap through basin hole (don't forget the rubber washer between the tap and basin), use the supplied plastic backnut by inverting it and threading it on the tap first so the male part fits in the sink hole, then use the brass one until the two are back to back, tighten and job done.
23 May 2016
Rated 4 out of 5Â by 182pete Better than plastic !
I needed to replace my worn out taps, which had plastic nuts, which seemed difficult to tighten. After reading reviews i decided to but these nuts, which are much easier to tighten
21 Apr 2016